Table of Contents
Advertisement
Electrical Connections
Using the ISO Connector
1. If your car is equipped with the ISO con-
nector, then connect the ISO connectors as
illustrated.
2. For connections without the ISO connec-
tors, check the wiring in the vehicle carefully
before connecting, incorrect connection may
cause serious damage to this unit.
Cut the connector, connect the colored
leads of the power cord to the car battery,
as shown in the colour code table below for
speaker and power cable connections.
Function
Location
Connector A
Connector B
Rear Right (+) - Purple
1
Rear Right (-) - Purple /
2
Telephone-mute/Pink
Black Stripe
Front Right (+) - Gray
3
Front Right (-) - Gray /
4
Battery 12V(+)/Yellow
Black Stripe
ANT/Amp control/
Front Left(+) - White
5
Blue
Lighting Connection/
Front Left(-) - White /
6
Brown
Black Stripe
Rear Left (+) - Green
7
ACC+/Red
Rear Left (-) - Green/
8
Ground/Black
Black Stripe
Anti-Theft System
This unit is equipped with a flip-down detachable
panel.
Panel can be detached and taken with you,
helping to deter theft.
Removing the Panel
1. Switch off the power of the unit.
2. Press button to flip down the panel.
3. At an angle hold the panel to pull it out.
4. Place the panel into the case and take it
with you when you leave the car.
15
Installing the Panel
1. Hold the panel and ensure the panel faces
toward you, and set the right side of the
panel in the panel bracket.
2. Press the left side of the panel until it locks.
Removing the Unit
1. Remove the panel and the trim plate.
2. Insert both removal keys into hole on the
front of the set until they lock.
3. Pull out the unit.
Advertisement
Table of Contents
