Daikin McQuay IOM 1177 Installation Operation & Maintenance Data

Room temperature sensor – adjustable cool/warm with occupancy switch

Advertisement

Quick Links

Room Temperature Sensor – Adjustable Cool/Warm With
Occupancy Switch (Sensor Part No. 910121753)
Used With:
Water Source Heat Pumps
▪ SmartSource Units with MicroTech
▪ Enfinity™ Units with MicroTech III Controls – Models CCH, CCW; VFC, VFW;
LVC, LVW; MHC, MHW & VHC, VHF
©2012 McQuay International
Installation Operation & Maintenance Data
Operator, save these instructions for future use!
800.432.1342
www.mcquay.com
III Controls – Models GS & GT
®
IMPORTANT!
IOM 1177
Group: WSHP
Part Number: 910133392
Date: July 2012

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IOM 1177 and is the answer not in the manual?

Questions and answers

Summary of Contents for Daikin McQuay IOM 1177

  • Page 1 Installation Operation & Maintenance Data IOM 1177 Group: WSHP Part Number: 910133392 Date: July 2012 Room Temperature Sensor – Adjustable Cool/Warm With Occupancy Switch (Sensor Part No. 910121753) Used With: Water Source Heat Pumps ▪ SmartSource Units with MicroTech III Controls – Models GS & GT ®...
  • Page 2 For proper disposal of a product containing mercury or a sealed container of spilled mercury, place it in a suitable shipping container. Refer to www.thermostat-recycle. org for location to send the product containing mercury. Page 2 of 8 / IOM 1177...
  • Page 3 Note: With optional Boilerless controls Termination Daikin McQuay recommends using twisted pair of at least conduit as AC power wiring. Fluctuating and inaccurate 22AWG and sealant filled connectors for all wire connec- signal levels are possible when AC power wiring is present in tions.
  • Page 4 7. Attach cover by placing the top of the cover on the back base and snapping the bottom into position. Figure 1: Junction box mounting Field provided thermostat wiring Junction box #6-32 × 1/2 mountings screws Page 4 of 8 / IOM 1177...
  • Page 5 5 - Ground or Neutral. Common Reference for All Signal Terminals E – Emergency Shutdown. (Terminal grounded when in System “Off” mode, VDC only) U - Unoccupied Contact. (Terminal grounded when in Unoccupied, VDC only) IOM 1177 / Page 5 of 8...
  • Page 6 • Status LED – This green LED will light to indicate the for unit status LED definitions. system status. See Table 8 Page 6 of 8 / IOM 1177...
  • Page 7 This page left blank intentionally IOM 1177 / Page 7 of 8...
  • Page 8 ©2012 McQuay International • 800.432.1342 • www.mcquay.com IOM 1177 / Page 8 of 8...

Table of Contents