1. Manuals
  2. Brands
  3. MediaForte Manuals
  4. Sound Card
  5. SF16-FMD2
  6. User manual

MediaForte SF16-FMD2 User Manual

16-bit 3-d sound board with fm radio
Hide thumbs
Table of Contents

Advertisement

Quick Links

SF16-FMD2
16-Bit 3-D Sound Board with FM Radio
User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SF16-FMD2 and is the answer not in the manual?

Questions and answers

Related Manuals for MediaForte SF16-FMD2

Summary of Contents for MediaForte SF16-FMD2

  • Page 1 SF16-FMD2 16-Bit 3-D Sound Board with FM Radio User Manual...
  • Page 3 SF16-FMD2 16-Bit 3-D Sound Board with FM Radio User Manual All rights reserved. No part of this publication may be produced, transmitted, transcribed, stored in any retrieval system, or translated into any language in any form by any means without written permission.

  • Page 4: Fcc Notice

    FCC Notice This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications.

  • Page 5: Table Of Contents

    Contents Read This First Board Layout ..................1-1 Connector Pinouts ................1-2 Installation Under Windows 95 Installing Windows Drivers .............. 2-1 Installing Sound Blaster 16 Software ..........2-5 Installing RadioAKTIV ..............2-6 Specifications Compatibility ..................A-1 Music Synthesizer ................A-1 Digital Audio ..................

  • Page 7: Read This First

    Read This First This chapter identifies the location and function of each connector on the SF16-FMD2 board. Board Layout The diagram below shows the layout of the SF16-FMD2: MVOL PCSPK ..CON4 ANTENNA IN LINE IN CON1 MICROPHONE IN...

  • Page 8: Connector Pinouts

    Pin 1 Pin 2 Pin 3 Vol - Ground Vol + J4 -- Speaker-Out connector Pin 1 Pin 2 Pin 3 Pin 4 Left Ground Ground Right J5 -- PC Speaker input connector Pin 1 Pin 2 Signal SF16-FMD2 User Manual...

  • Page 9: Installation Under Windows 95

    Windows 95 notifies that it has detected a Creative ViBRA16X PnP-based sound board as shown below: Insert the SF16-FMD2 CD into the CD-ROM drive, wait for the drive to be ready, then click the Next > button. Installation Under Windows 95...
  • Page 10 Type in the CD-ROM drive letter (eg. D:\) at the "Copy files from:" text box and click the OK button to continue. Windows starts copying all necessary files from the CD into the hard disk. It then reports that a joystick has been found. SF16-FMD2 User Manual...
  • Page 11 Insert the Windows 95 CD when prompted. Windows next reports that it has found the FM radio hardware and needs to locate the correct drivers. 9. Insert the SF16-FMD2 CD into the CD-ROM drive. Click the Next > button. Installation Under Windows 95...
  • Page 12 OK button to close the message box. In the "Copying Files..." dialog box, type in D:\ at the "Copy files from" text box (where D: is the CD-ROM drive letter). Click the OK button. Windows 95 completes installation of the radio driver. SF16-FMD2 User Manual...

  • Page 13: Installing Sound Blaster 16 Software

    Installing Sound Blaster 16 Software To install the suite of Sound Blaster 16 software, do the following: 1. Insert the SF16-FMD2 CD into the CD-ROM drive. Wait for the drive to be ready. 2. Click the button at the Windows Taskbar.

  • Page 14: Installing Radioaktiv

    Installing RadioAKTIV To install the RadioAKTIV FM Radio Navigator, do the following: 1. Insert the SF16-FMD2 Installation CD into the CD-ROM drive. Wait for the drive to be ready. 2. Click the button. 3. Select the Run... command, type in D:\RADIO\SETUP.EXE (where D: is the CD-ROM drive letter) at the "Open"...

  • Page 15: Specifications

    The SF16-FMD2 sound board uses Creative Technology's CT2511 ViBRA 16X chipset, and is capable of full-duplex and 3D sound output. This chapter details the specifications of the SF16-FMD2 sound board: Compatibility q Sound Blaster 2.0, Sound Blaster Pro, Sound Blaster 16...

  • Page 16: Analog/Digital Mixer

    Full software control for fade-in, fade-out and panning Internal Amplifier q 4-watts per channel stereo output into 4-ohm load q Support for external amplifier Joystick Interface q Standard for external interface MIDI Interface q Roland MPU 401 (UART mode) port emulation SF16-FMD2 User Manual...

  • Page 17: Fm Radio Features

    FM Radio Features q Compatible with Windows 95, Windows NT 4.0 workstation q Built-in high quality stereo FM radio tuner IC q Frequency range : VHF Band II (88Mhz to 108Mhz) q Dipole antenna to improve reception in PC q Antenna impedance : 75 ohms q 20-preset stations q User-friendly Graphic User Interface provides ease of tuning, on/off, and presetting...

Table of Contents