Download Print this page

Sound Stages SSON12 User Manual

Designed for 2012 and newer chevrolet sonic vehicles

Advertisement

Quick Links

SSON12
Designed for 2012 and newer Chevrolet
®
Sonic vehicles
©2012 Stillwater Designs
SSON12-A2-20121010
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the SSON12 and is the answer not in the manual?

Questions and answers

Summary of Contents for Sound Stages SSON12

  • Page 1 SSON12 Designed for 2012 and newer Chevrolet ® Sonic vehicles ©2012 Stillwater Designs SSON12-A2-20121010...
  • Page 2 Subwoofer Assembly Subwoofer Body Harness Subwoofer Power Harness 25A Fuse Wire Ties x6 Foam Strip Wire Taps x2 Adapter Harness...
  • Page 3 Power Wire Routing 1. Disconnect the negative battery cable from the battery. 2. Using a razor knife make a cross shaped incision in the large rubber grommet from inside the vehicle and feed the power wire from the engine compartment to the cabin. Using a fi sh tape wire is recommended. Fig.
  • Page 4 10. Remove the drivers side cover directly in front of the console by removing the plastic retainer with a Phillip’s screwdriver and then pull the cover loose. If installing the optional amplifi er system, the passenger’s side panel will need to be removed as well but has no plastic retainer and can simply be pulled off. Fig. 4 11.
  • Page 5 18. Continue running the subwoofer harness down the drivers side of the car to and under the rear seatback. It is helpful to rotate the seatback down to allow clearance for the connecters. Secure any excess harness to the factory harness under the driver’s side rear threshold panel. Subwoofer Installation NOTE: If you your vehicle is a 5-door model, remove the spare tire to retrieve the spare tire safety strap equipped with the vehicle, and then replace the spare tire.
  • Page 6 Hatchback installation shown 24. With the seatback in the up position set the subwoofer in place against the back of the seatback. Release the seatback and while holding the top of the subwoofer against the seatback slowly rotate the seatback forward until the subwoofer bracket slides under the anchor point on the seatback.
  • Page 7 Symptom Possible Cause Solution Fuse not installed in inline fuse Install fuse into fuse holder. holder on subwoofer and / or amp Refer to instructions for correct harness placement Low battery voltage Recharge the battery Negative battery cable not Reconnect negative battery cable connected Power wire connecter not Connect power wire to body...