IST T120 – MINISOL Owner's Manual

T120 – MINISOL
10W LED TORCH
OWNER'S MANUAL
Ver. E1001129H
Thank you very much for purchasing IST MINISOL dive torch. The T120 is super compact but the amount
of illumination it produces is unrivalled by anything similar in size on the market toady. The ultra bright
10w LED and its rechargeable lithium‐ion battery are housed in a sturdy, marine‐grade aluminium
housing. To get the most out of this torch, please read through the manual completely before using this
product. Should you have any question, please do not hesitate to contact your nearest IST authorised
dealer or distributor for assistance.
CHARGING THE BATTERY:
Before using your torch for the first time, please charge and make sure the battery's
power capacity is full.
Although lithium‐ion battery has no memory effect, for your convenience, it is a good
practice to charge it soon after each use so it can be ready for your next use.
NEVER use any other charger other than the one that comes with the torch!
1. Make sure the torch's exterior is dry, clean and dust free – it is important that no moisture shall
come in contact with the battery or any electronic components.
2. To remove the battery, turn the battery compartment end cap counter‐clockwise until it comes off.
3. Plug the appropriate end of the charger's electrical cord to a wall socket and the charger. When
power is going through the circuit, the light in the wall socket end of the cord (green) and the
charger (yellow, on the right) will come on.
4. Slide the battery into the charger. If the LED bulb on the left is red, it means more charging is needed;
if the LED is green, it means it is ready.
Charging is best performed in cool temperature. Do not cover the battery and charger
while charging.
5. Although the charger has a built‐in over‐charging protection, don't leave the battery sitting in the
charger in a fully charged state.
6. While charging, it is a good time to check if the twin o‐rings are in good, usable conditions (free of
dirt, cracks, cuts, deformed) and change to new ones if necessary. Also check the inside of the
battery compartment cap for cleanliness. Apply silicone grease to the o‐rings before putting the cap
back on.