Durabrand DVD-1002 Instruction Manual page 24

TROUBLE SHOOTING
Symptom
No button operates (on
the main unit and/or the
R EM OT E CONT ROL
unit).
Cannot change a menu
item.
Audio soundtrack and/
or subtitle language is
not at the initial settings.
No subtitles.
Alternative
soundtrack (or subtitle)
Language does not
show.
Angle cannot be
changed.
Images appear distorted.
If your TV set does not
have Audio / Video input
jacks.
Picture is frozen.
Screen saver appears
on TV screen.
Can not copy discs to
VHS video tapes.
Picture is too short.
Progressive scan
doesn't work.
IB-DVD1002(AT)-WM-E-032706.pmd
Press the ON/STANDBY button on the remote to set the player to
the standby mode and then press the ON/STANDBY button again
to turn the player to ON. Reset the DVD player by disconnecting
the power plug and then re-connecting it (the player may not be
operating properly due to lightning, static electricity, damaged or
wrong discs, or some other external factors).
Try changing this item with the DVD door open (not during play).
If the audio soundtrack and / or subtitle language does not exist
on the disc, the language selected at the initial setting will not be
heard/seen. Try setting it up again, see Page 13.
Subtitles appear only on discs which contain them.
If subtitles don't show, press the SUBTITLE button to display
the subtitles.
An alternative language is not possible with discs which do not
audio
have more than one language. In the case of some discs, the
alternative language cannot be selected by operating the AUDIO
or SUBTITLE buttons. Try selecting it from the DVD menu if one
is available.
This function is dependent on the DVD disc. Even if a disc has a
number of angles recorded, these angles may be seen only on
specific scenes.
If faces seem stretched and too long, your TV shape may be
adjusted to 16:9 ratio. Please adjust it to 4:3 for better results or
match to your TV type, see page 12.
1. Buy a newer TV with these jacks.
2. You may try using your VCR's jacks but the color may be
distorted due to macrovision licensed DVD protection (against
copying discs).
3. Your dealer can sell you an RF Modulator which converts the
signals for inputting into the TV's RF input (antenna) jacks.
However, your results will never be as good as a new modern
TV with proper input jacks.
If a button is pressed too fast over and over, the signals may jam
the circuits inside. To restore to normal, press STOP button and
open the disc door to reset the circuits.
Turn off screen saver by pressing any button on the REMOTE
control.
You can't copy most commercial movie discs due to copy
protection built into the disc.
Change the picture screen type, see page 12.
1. Check your cables if output matches input.
2. Does your TV support progressive scan? if not, use normal or
S-Video jacks, set your player to S-Video output. (see page 14.)
24
Remedy
IB-DVD1002 (AT)-WM-E-032706
23
7/5/2006, 10:24 AM