Connections - Durabrand DVD-1002 Instruction Manual

CONNECTIONS

Connect your player to TV using one of the 3 diagrams below.
Good – Composite (Normal)
YOUR TV SET
WHITE YELLOW
RED
YOUR DVD PLAYER
Cr/Pr Cb/Pb Y S-VIDEO VIDEO OUT COAXIAL
Connect the DVD player to your TV with the
supplied video (yellow) and audio (red &
white) cables as above. In this connection,
please set the video output mode to S-VIDEO
(see page 14).
YOUR TV SET
COMPONENT VIDEO IN
Cr/Pr
YOUR DVD PLAYER
VIDEO OUT COAXIAL R - AUDIO - L
S-VIDEO
Cr/Pr Cb/Pb Y
Connect the DVD player to your
TV with the optional Component
video cables (not included) and
the supplied audio cables (red &
white) to your TV if your TV has
component video inputs (Pb/Pr/
IB-DVD1002(AT)-WM-E-032706.pmd
(TV set)
YELLOW RED WHITE
R - AUDIO - L
Best – Component
Y or Cb/Cr/Y) as shown. In this connection, please set
the video output mode to YUV (see page 14).
Cb/Pb Y IMPORTANT
The progressive scan video quality is available only when
using component video inputs Pb/Pr/Y and a progressive
scan TV. Compared to interlaced video, progressive scan
video effectively doubles the scanning rate of the picture
and offers higher picture resolution and quality, resulting in a
very stable, flicker-free image. You can enter the Progressive
Scan Video mode with the following steps:
1. Set the Video Output mode to YUV (see page 14).
2. Fully stop your DVD player.
3. Open the disc door.
4. Press the DISPLAY/P-SCAN button, the display will
show the tip of "ENABLE PROGRESSIVE", use the
button to highlight "OK" option and press the OK button
to confirm.
NOTE: If you want to use Normal video or S-video
mode again, please open the disc door and press the
DISPLAY/P-SCAN button to get out of the Progressive
Scan Video mode and view in normal video mode. (If this
is not done, there will be no picture or a distorted picture.)
5
Better – S-Video
YOUR TV SET
RED WHITE
YOUR DVD PLAYER
Cr/Pr Cb/Pb Y
For better picture quality, connect the DVD player
to your TV with an optional S-Video cable (not
included) and the supplied audio (red & white)
cables to your TV if your TV has an S-Video
input as above. In this connection, please set the
video output mode to S-VIDEO (see page 14).
4 IB-DVD1002 (AT)-WM-E-032706
7/5/2006, 10:24 AM
RED WHITE
S-VIDEO VIDEO OUT COAXIAL R - AUDIO - L