Pdx-089T Development Note - Icop PDX-089T-D5A-512 User Manual

3.1.

PDX-089T Development Note

<Primary /Secondary IDE: Master or Slave>
Micro SD: Primary Master
CF Slot: Secondary IDE: Master or Slave (User can use slide switch (in side of CF
slot) to adjust Master or Slave
<Window CE6.0 development guide>
Windows Embedded CE 6.0 BSP, trial CE image and development notes, please visit
technical website to get more information: http://tech.icop.com.tw/
<Linux installation note>
Please forced the IDE setting in BIOS to PIO mode before install Linux
on PDX-089T as follows:
1-Go to the advanced BIOS setting and make the "Onboard IDE Operate Mode" is
"Legacy Mode"
2-Go to the PCI/PnP and make the "PCI IDE BusMaster" is "Disable"
< XP professional /Home /Embedded and Windows 2000 installation note >
1-Please visit technical website to get more information: http://tech.icop.com.tw/
<Enhance CF to run the UDMA2/4>
1-Please select ICOP "ICF Card" to supporting UDMA 2/4 Mode.
<How to boot up from the Micro SD card>
1-Get into the BIOS setup Utility
2-Go to the Advanced
3-Choose Primary IDE Pin Select: SD card
4-Press "F10" to save configuration changes and exit setup
<Backlight On/Off through GPIO control>
Sample Code:
PDX-089T
DM&P Vortex86DX Panel PC with 8.9" WSVGA TFT LCD
23