Nintendo 3DS XL Operation Manual page 21

Connecting using AOSS
If your access point supports AOSS, you can set up a connection quickly and easily. Refer to the instruction manual for your access point in addition
to this manual.
Note: Using AOSS may cause your access point settings to change.
no longer be able to connect after using AOSS. Establishing a connection using an access point found through a search will not change any of
the access point's settings ( p. 42).
Touch AOSS
1
Note: If you are using the tutorial and you have selected
2
Steps for the access point
Press and hold the AOSS button on the access point until the
AOSS light flashes twice in succession.
Note: If you have tried and failed several times to set up a connection using AOSS, wait approximately
5 minutes before trying again.
Once the setup complete screen appears, touch OK to begin a connection test
3
•
If the test is successful, setup is complete.
•
Failure to establish a connection can sometimes occur after AOSS setup is complete. If this happens, please wait a short while
before trying to reconnect.
40
If your computer is connected to the access point without using AOSS, it may
, start from step .
2
AOSS button
Connecting using Wi-Fi Protected Setup
You can set up a connection quickly and easily using Wi-Fi Protected Setup. Refer to the instruction manual of your access point for further
information.
Note: If your access point is set to use WEP security encryption, you will be unable to connect your Nintendo system using Wi-Fi Protected Setup.
Touch
1
Note: If you are using the tutorial and you have selected
Touch the connection method supported
2
by your access point
Steps for the access point
3
Note: It may take around 2 minutes to complete setup.
For Push-Button Connection
Press and hold the Wi-Fi Protected Setup button on the access point until the LED blinks.
For PIN Connection
A PIN will be displayed on the Touch Screen. Enter the code into the access point
settings, then touch NEXT.
Note: After configuring the access point, touch NEXT on your system's Touch Screen.
Once the setup complete screen appears, touch OK to begin a connection test
4
•
If the test is successful, setup is complete.
•
Failure to establish a connection can sometimes occur after Wi-Fi Protected Setup is complete. If this happens, please wait a short
while before trying to reconnect.
, start from step .
2
Wi-Fi Protected
Setup button
41