Summary of Contents for Evalue Technology EES-3610 Series
-
Page 1: Quick Reference Guide
Quick Reference Guide EES-3610 Series VIA Eden Micro PC Ed. – 5 May 2004 Part No. 2017361062... -
Page 2: Fcc Statement
EES-3610 FCC STATEMENT THIS DEVICE COMPLIES WITH PART 15 FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE. (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED INCLUDING INTERFERENCE THAT CAUSE UNDESIRED OPERATION. -
Page 3: Copyright Notice
Disclaimer Evalue Technology Inc. reserves the right to make changes, without notice, to any product, including circuits and/or software described or contained in this manual in order to improve design and/or performance. Evalue Technology assumes no responsibility or liability for the... -
Page 4: Life Support Policy
EES-3610 Life Support Policy Evalue Technology’ s PRODUCTS ARE NOT FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE PRIOR WRITTEN APPROVAL OF Evalue Technology Inc. As used herein: 1. Life support devices or systems are devices or systems which, (a) are intended for... - Page 5 E-mail: service@evalue-tech.com E-mail: service.europe@evalue-tech.com China Branch Office US Branch Office Evalue Technology Shanghai Inc. Evalue Technology Inc. Room 909, 9F, Section B, No.900, Suite 210, 200 Tornillo Way, Yisan Road, Caohejing Hi-tech Park, Tinton Falls, NJ 07712 Shanghai 200233, China...
- Page 6 EES-3610 Product Warranty Evalue warrants to you, the original purchaser, that each of its products will be free from defects in materials and workmanship for two years from the date of purchase. This warranty does not apply to any products which have been repaired or altered by persons other than repair personnel authorized by Evalue, or which have been subject to misuse, abuse, accident or improper installation.
-
Page 7: Packing List
Quick Reference Guide Packing List Before you begin installing your Micro PC, please make sure that the following materials have been shipped: 1 EES-3610 VIA Eden Micro PC (with ECM-3610 inside) 1 Quick Reference Guide 1 CD-ROM contains the followings: —... -
Page 8: Safety Precautions
EES-3610 1. Safety Precautions Warning! Always completely disconnect the power cord from your chassis whenever you work with the hardware. Do not make connections while the power is on. Sensitive electronic components can be damaged by sudden power surges. Only experienced electronics personnel should open the PC chassis. Caution! Always ground yourself to remove any static charge before touching the CPU card. -
Page 9: Specifications
Quick Reference Guide 2. Specifications Palm size (220 x 147 x 65 mm) VIA Eden series CPU Board Rugged Aluminum Alloy Chassis w/ 2.5" HDD Mounting Kit Dual RJ-45 10/100Base-Tx Interfaces (EES-3610 only, optional Intel LAN chips) DB-15 VGA Interface Mic-In / Line-In / Line-Out Audio Jacks CF+ Type I/II Socket with Ejector 2 COMs / 2 USB / 1 Parallel Port... -
Page 10: System Overview
EES-3610 3. System Overview Front Panel Label Function Note Power OFF/ON System Power Switch System Power Indicator EES-3610 Quick Reference Guide... - Page 11 Quick Reference Guide Rear Panel Label Function Note Compact Flash CF+ Type I/II Socket with Ejector COM1 Serial Port 1 DB-9 male connector COM2 Serial Port 2 DB-9 male connector DC-IN DC Power-in Plug 5.5*2.1*9.5 mm HDD Activity Indicator KB/MS Keyboard and PS/2 mouse connector 6-pin mini DIN 10/100Base-Tx Ethernet 1 connector...
- Page 12 EES-3610 4. Hardware Configuration for ECM-3610 Micro Module Installation Procedure 1. Unplug the power adapter from EES-3610. 2. Make sure all external cables are unattached. 3. Unscrew the front panel. 4. Disassemble the top cover for HDD installation, or 5. Disassemble the bottom cover for memory and/or CF card installation. Installing DRAM (SODIMM) 4.2.1 System Memory...
- Page 13 Quick Reference Guide Jumper & Connector 4.3.1 Jumper & Connector Layout EES-3610 Quick Reference Guide 13...
- Page 14 EES-3610 4.3.2 Jumper & Connector List Connectors on the board are linked to external devices such as hard disk drives, keyboard, mouse, or floppy drives. In addition, the board has a number of jumpers that allow you to configure your system to suit your application. The following tables list the function of each of the board's jumpers and connectors.
- Page 15 Quick Reference Guide Connectors Label Function Note Serial port 2 connector 5 x 2 header, pitch 2.0mm Serial port 1 connector DB-9 male connector Secondary LCD panel connector HIROSE DF13-40DP-1.25V Primary LCD panel connector HIROSE DF13-40DP-1.25V CN3, CN4 PC/104 connector IDE connector 20 x 2 header, pitch 2.54mm CPU fan connector...
- Page 16 EES-3610 Jumper Settings 4.4.1 Clear CMOS (J4) You can use J4 to clear the CMOS data if necessary. To reset the CMOS data, set J4 to 2-3 closed for just a few seconds, and then move the jumper back to 1-2 closed.
- Page 17 Quick Reference Guide 4.4.3 AT/ATX Power Select (ATATX1) You can use ATATX1 to select the power supply type. To use the AT power supply, set ATATX1 to 1-2 closed. Set ATATX1 to 2-3 closed, if ATX power supply is to be used.
- Page 18 EES-3610 Connector Definitions 4.5.1 Pin Header Serial Port 2 Connector in RS-232 Mode (CM1) Signal Signal 4.5.2 Pin Header Serial Port 2 Connector in RS-422 Mode (CM1) Signal Signal 4.5.3 Pin Header Serial Port 2 Connector in RS-485 Mode (CM1) Signal Signal DATA+...
- Page 19 Quick Reference Guide 4.5.4 Secondary LCD Panel Connector (CN1) Signal Signal 3.3V 3.3V Vcon EES-3610 Quick Reference Guide 19...
- Page 20 EES-3610 4.5.4.1 Primary LCD Panel Connector (CN2) Signal Signal 3.3V 3.3V Vcon SHFCLK ENVEE ENBKL EES-3610 Quick Reference Guide...
- Page 21 Quick Reference Guide 4.5.5 Signal Description – Primary & Secondary LCD Panel Connector (CN2, CN1) P [35:0] Flat Panel Data Bit 35 to Bit 0 for panel implementation. SHFCLK Shift Clock. Pixel clock for flat panel data Latch Pulse. Flat panel equivalent of HSYNC (horizontal synchronization) First Line Marker.
- Page 22 EES-3610 4.5.6 Signal Configuration – DSTN Displays DSTN Pin name 8-bit 16-bit 24-bit 8-bit 16-bit 24-bit 16-bit 24-bit EES-3610 Quick Reference Guide...
- Page 23 Quick Reference Guide 4.5.7 Signal Configuration – TFT Displays Pin name 9-bit 9-bit x 2 12-bit 12-bit x 2 15-bit 15-bit x 2 18-bit 18-bit x 2 24-bit Note: The principle of attachment of TFT panels is that the bits for red, green, and blue use the most significant bits and skip the least significant bits if the display interface width of the TFT panel is insufficient.
- Page 24 EES-3610 4.5.8 CPU Fan Connector (CN6) Signal 4.5.9 Audio Connector (CN7) Signal Signal Mic Bias Mic-In Line-In L Line-In R Line-Out L Line-Out R 4.5.10 CD-ROM Audio Input Connector (CN8) Signal CD_GND CD_L CD_GND CD_R 4.5.11 IrDA Connector (CN9) Signal IRRX IRTX EES-3610 Quick Reference Guide...
- Page 25 Quick Reference Guide 4.5.12 ATX Power Connector (J1) Signal PS_ON VCC_SB Note: Set J1 to 2-3 closed, if AT power supply is to be used. 4.5.13 ATX Soft-power Connector (J2) Signal PWRBTN 4.5.14 LCD Inverter Connector (J3) Signal ENBKL +12V Note: For inverters with adjustable Backlight function, it is possible to control the LCD brightness through the VR signal (pin 4) controlled by VR1.
- Page 26 EES-3610 4.5.15 Auxiliary Power Connector (PWR1) Signal -12v 4.5.16 Power Connector (PWR2) Signal EES-3610 Quick Reference Guide...
- Page 27 Quick Reference Guide 4.5.17 USB Connector (USB1) Signal Signal VCC1 VCC2 4.5.18 Signal Description – USB Connector (USB1) D1+ / D1- Differential bi-directional data signal for USB channel 0. Clock is transmitted along with the data using NRZI encoding. The signalling bit rate is up to 12 Mbs. D2+ / D2- Differential bi-directional data signal for USB channel 1.
- Page 28 EES-3610 4.5.19 LCD Backlight Brightness Adjustment Connector (VR1) Signal J3 pin 4 Variation Resistor (Recommended: 4.7K£[, >1/16W) 4.5.20 STN LCD Contrast Adjustment Connector (VR2) Signal VCON EES-3610 Quick Reference Guide...
- Page 29 Quick Reference Guide 5. Mechanical Drawings Dimension Drawing EES-3610 Quick Reference Guide 29...
- Page 30 EES-3610 Explode Drawing EES-3610 Quick Reference Guide...
- Page 31 Quick Reference Guide Chassis Part List EES-3610 Quick Reference Guide 31...
- Page 32 EES-3610 EES-3610 Quick Reference Guide...
Need help?
Do you have a question about the EES-3610 Series and is the answer not in the manual?
Questions and answers