FW-1042 Quick Setup Guide Packing List Description FW-1042 Power Cable Rack Mount Ears Rack Mount Screws (Large) Drive Mounting Screws (Small) Safety Warning: The use and installation of this system should only be performed by professionals. Improper installation of any electronic device or electrical component can result in serious injury or death.
Page 2
Install Guide Step 1 - Inspect Contents Unpack all package contents and inspect each component. Make sure all included parts and accessories are present. Step 2 - Remove Top Cover Using a phillips head screw driver, remove the four screws on the sides of the enclosure. Using a phillips head screw driver, remove the single screw at the top rear of the enclosure.
Page 3
Step 5 - Memory Locate the memory slot. Ensure memory is a 204- Pin SO DIMM. Align notch in memory circuit with corresponding guide on the memory slot. Insert the memory circut at a 45° angle and press the circuit flat and secure it to the memory slot with an audible click on each side of the memory slot.
Page 4
Line-Out USB2.0 Power PS/2 Line-In Dimensions 250mm / 9.8” 44mm / 1.75” 425mm / 17” 170 mm / 6.7” 170 mm / 6.7” 21015 Commerce Pointe Drive, Walnut, CA 91789 www. habeyusa.com Copyright@2014. Habey USA. All Rights Reserved. Version 1.