Page 1
WEX-QM771 Intel QM77 User Manual Rev.01, Jun. 2013...
Page 2
All trademarks are the properties of the respective owners. All product specifications are subject to change without prior notice Packing List □ WEX-QM771 □ Driver CD (Include user’s manual) Ordering Information □ 1 x PS2 Y Cable(KB and Mouse) □...
Chapter 1 Product Information This chapter introduces the product features, jumper and connector information. 1.1 Block Diagram Intel CHA DDR3 DDR3 1333 SO-DIMM rPGA988B Processor USB 3.0 USB 3.0 (x2) Intel DDPC USB 2.0 USB 2.0 (x4) QM77 PCH DP stack connector DDPD SATA 3.0 SATA 3.0 (x2)
1.2 Features Intel® 3rd generation Core™ i7/ i5/ i3 processors (Ivy Bridge) Processor System Processor/ Socket G2 (rPGA988B) Chipsets Chipset Intel® QM77 BIOS Technology DDR3 1333/1600 MHz SDRAM Max. Memory Up to 8GB DDR3 DRAM Capacity Socket 1x DDR3 SO-DIMM Chipset Intel QM77 integrated Intel®...
Page 6
LVDS 24bit 1 1 x RS232 Audio 1(Line In, Line out, Mic in) Front Panel 1 8 bit programmable digital input/output Rear I/O 1 x RJ45 USB 3.0 DC 12V Input 1 Power Interval Programmable 1~255 sec./min. Watchdog Timer Output System reset Operating -5°C~60°C (23°F~140°F)
1.5 Connector Function List Connector Function Note AUDIO Line-In/MIC-In/Line-Out with Pin-header CHA-DIMM DDR3 SO-DIMM connector COM1 Serial port connector COM2 Serial port connector with pin-header CPUFAN CPUFAN 4-pin connector Digital input/output with pin-header Display port connector LCD inverter with box-header JFRONT Front panel with pin-header JLPC...
1.6 Internal Connector Pin Define AUDIO: Audio with Pin-header (2.0mm) Pin No. Signal Pin No. Signal Line-in Right Line-in Left Line-in Jack Detect MIC Jack Detect MIC-in Right MIC-in Left Line-out Jack Detect Audio Ground Line-out Right Line-out Left COM2: Serial Port with Pin-header (2.0mm) Pin No.
Page 12
INV: Inverter with Box-header (2.50mm) Pin No. Signal +12V Ground Inverter Brightness Adjust Inverter Enable JSMB: SMBUS with Pin-header (2.0mm) Pin No. Signal SMB_CLK SMB Data Ground JFRONT: Front Panel with Pin-header (2.54mm) Pin No. Signal Pin No. Signal +5V (470 Ohm) Power LED –...
Page 13
JLPC: Debug Port with Pin-header (2.0mm) Pin No. Signal Pin No. Signal LAD0 LPC Reset# LAD1 LFRAME# LAD2 +3.3V LAD3 Ground LPC33MHz LCD: LVDS Panel Signal with Box-header (1.0mm) Pin No. Signal Pin No. Signal Ground Ground LVDSA_DATA3+ LVDSA_DATA3- LVDSA_CLK+ LVDSA_CLK- LVDSA_DATA2+ LVDSA_DATA2-...
Page 14
SATA_PWR: SATA Power with Box-header (2.50mm) Pin No. Signal Ground Ground +12V SYSFAN: System FAN 3 Pin connector Pin No. Signal Ground Fan Power (+12V) Speed Sense USB1, 2: USB with Pin-header (2.0mm) Pin No. Signal Pin No. Signal USB Power USB Power (+5V) (+5V)
BIOS Information language BIOS Vendor American Megatrends Core Version 4.6.5.3 Compliancy UEFI 2.3; PI 1.2 Project Version 1APTC 0.24 X64 WEX-QM771 RA01 Model Name BIOS Version 0000-00-000 BIOS Tag 05/16/2013 15:17:13 Build Date and Time Processor Information Name IvyBr idge...
2.2 Advanced Menu This section allows you to configure CPU and other system devices for basic operation through the following sub-menu. Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Main Advanced Chipset Boot Security Save & Exit Advanced Disable/Enable RTC to generate a wake event.
2.4 CPU Configuration Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Advanced CPU Configuration Intel(R) Core(TM) i5-3610ME CPU @ 2.70GHz CPU Signature 306a9 Microcode Patch Max CPU Speed 2700 MHz Min CPU Speed 1200 MHz CPU Speed 2700 MHz Processor Cores Intel HT Technology...
2.5 SATA Configuration Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Advanced Enable or disable SATA [Enabled] SATA Controller(s) Device [IDE] SATA Mode Selection [Native] IDE Legacy / Native Mode Selection Empty Serial ATA Port 0 Unknown Software Preserve Empty Serial ATA Port 1...
2.6 AMT Configuration Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Advanced Intel AMT [Enabled] Enable/Disable Intel (R) BIOS Hotkey Pressed [Disabled] Active Management Technology BIOS Extension. MEBx Selection screen [Disabled] Hide Un-Configure ME Confirmation [Disabled] Note : iAMT H/W is always MEBx Debug Message Output [Disabled] enabled.
Page 21
□ MEBx Debug Message Output The item allows users to enable or disable MEBx debug message. Choices: Disabled, Enabled. □ Un- Configure ME If the setting is default, the option is “Disabled”. Choices: Disabled, Enabled. □ Amt Wait Timer The item is set to wait time to enter AMT to 0. □...
2.7 USB Configuration Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Advanced USB Configuration Enables Legacy USB support. AUTO option disables legacy support if no USB devices are USB Devices 1 Keyboard, 2 Hubs connect. DISABLE option will keep USB devices available only for EFI applications. Legacy USB Support [Enabled] USB3.0 Support [Enabled] XHCI Hand-off [Enabled] EHCI Hand-off [Disabled] USB hardware delays and time-outs: : Select Screen...
Page 23
□ USB Transfer time-out The item is for the time-out value for Control, Bulk, and Interrupt transfers. □ Device reset time-out The item is for USB mass storage device start unit command time-out. □ Device power-up delay The item is for maximum time and the device will take before it properly reports itself to the host controller.
2.8 Super IO Configuration Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Advanced Set Parameters of Serial F81866 Super IO Configuration Port 0 (COMA) F81866 Super IO Chip F81866 Serial Port 0 Configuration Serial Port 1 Configuration ERP Wake up [Enabled] Watch dog timer...
2.9 Serial Port 0 Configuration Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Advanced Enable or Disable Serial Serial Port 0 Configuration Port (COM) [Enabled] Serial Port IO=3F8h; IRQ=4; Device Settings [Auto] Change Settings : Select Screen : Select Item Enter : Select +/- : Change Opt .
2.10 Serial Port 1 Configuration Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Advanced Enable or Disable Serial Serial Port 1 Configuration Port (COM) Serial Port [Enabled] Device Settings IO=2F8h; IRQ=3; Change Settings [Auto] : Select Screen : Select Item Enter : Select +/- : Change Opt .
2.11 Pc Health Setting Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Advanced Enable or Disable Smart Pc Health Status Smart Fan Function [Enabled] Smart Fan Mode Configuration CPU Temp : +38 SYS Temp : +39 CPU FAN Speed : 6849 SYS FAN Speed : N/A...
2.12 Smart Fan Mode Configuration Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Advanced Smart Fan Mode Configuration Smart Fan Mode Select CPU Fan Smart Fan Control [Auto Duty-Cycle Mode] Temperature 1 Temperature 2 Temperature 3 Temperature 4 Duty Cycle 1 Duty Cycle 2 Duty Cycle 3...
2.16 Graphics Configuration Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Chipset Graphics turbo IMON current Graphics Configuration Values supported (14-31) 2137 IGFX VBIOS Version 350 MHz IGfx Frequency Graphics Turbo IMON Current [Auto] Primary Display [Auto] Internal Graphics [2MB]] GTT Size...
Page 33
□ DVMT Total Gfx Mem This item allows users to select DVMT total memory size. □ Gfx Low Power Mode This item is applicable for SFF only. □ Graphics Performance Analyzers enables or disables the Intel Graphics Performance Analyzer counters. This item □...
2.17 Memory Information Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Chipset Memory Information Memory Frequency 1333 Mhz Total Memory 2048 MB (DDR3) DIMM#0 2048 MB (DDR3) CAS Latency (tCL) Minimum delay time CAS to RAS (tRCDmin) Row Precharge (tRPmin) Active to precharge (tRASmin) : Select Screen...
2.18 Boot Configuration Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Main Advanced Chipset Boot Security Save & Exit Boot Number of seconds to wait Boot Configuration for setup activation key. Setup Prompt Timeout 65535(0xFFFF) means Bootup NumLock State [On] indefinite waiting.
Page 36
□ Option ROM Messages This item allows user to set display mode for option ROM. □ INT19 Trap Response This item allows option ROMs to trap interrupt 19.
2.20 Password Configuration Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Main Advanced Chipset Boot Security Save & Exit Security Password Description Set Administrator Password If ONLY the Administrator’s password is set , then this only limits access to Setup and is only asked for when entering Setup.
2.21 Save Changes and Exit Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc . Main Advanced Chipset Boot Security Save & Exit Save & Exit Save Changes and Exit Exit system setup after Discard Changes and Exit saving the changes. Save Changes and Reset Discard Changes and Reset Save Options...
Chapter 3 Drivers Installation This chapter introduces driver installation information. Please insert the utility CD to CD-ROM drive, the install menu will appear automatically, if the install menu do not list suitable driver of Operate System or appear automatically, please select corresponding driver of utility CD to install. The Windows XP driver installation steps are as below.
Page 42
Step 2. Read the License Agreement and click “Yes” to continue. Step 3. Click “Next” to continue.
Page 43
Step 4. Click “Next” to continue. Step 5. Click “Finish” to complete setup.