Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for CleanMaster Rexx 120 100-600-120
- Page 1 Rexx 120 Carpet And Upholstery Cleaner Model No.: Operator and Parts Manual 100-600-120 4 gal Extractor CLEANMASTER 11015 47 AVENUE WEST MUKILTEO WA 98275 U.S.A. FAX: 1-800-426-4225 MNL32321-REXX 120 WEBSITE: www.cleanmaster.com CUSTOMER SERVICE: 1-425-775-7276 Rev. 00 (03-01)
-
Page 2: Table Of Contents
© Cleanmaster Printed in U.S.A. distributor or directly from Cleanmaster. Cleanmaster is a registered United States trademark This machine will provide excellent service. However, the best results will be obtained at minimum costs if: • The machine is operated with reasonable care. -
Page 3: Safety Precautions
OPERATION 4. Before leaving or servicing machine: SAFETY PRECAUTIONS – Turn off machine. Unplug cord from wall outlet. – 5. When servicing machine: This machine is intended for commercial use. It is designed to wet clean carpet and upholstery in a –... -
Page 4: Safety Labels
OPERATION SAFETY LABELS The safety labels appear on the switch panel of the machine. Replace switch label if any become damaged or illegible. FOR SAFETY LABEL- Located on switch panel. FOR SAFETY: Read manual before operating machine. HAZARDOUS VOLTAGE LABEL- Located on switch panel. -
Page 5: Machine Components
OPERATION MACHINE COMPONENTS 8. Power Cord Connect 1. Recovery Tank 9. Vacuum Hose Connector 2. Solution Tank 10. Latches 3. Recovery Tank Lid 11. Recovery Tank Handle 4. Solution Tank Lid 12. Solution Hose Connector 5. Vacuum Switch 13. 76 mm (3”) Wheels, non-marking 6. -
Page 6: Machine Operation
OPERATION ATTENTION: If using powdered cleaning 2. Take carpet cleaning wand in hand and squeeze chemicals, mix prior to adding. valve trigger while moving the tool in short forward and backward strokes over the carpet NOTE: If desired, water alone achieves excellent (Figure 5). -
Page 7: Draining Tanks
OPERATION 2. Operate accessory tool as normal (Figure 7). DRAINING SOLUTION TANK NOTE: Before cleaning upholstery, always check 1. Turn on vacuum and remove water from solution cleaning instructions sewn in furniture by tank (Figure 11). manufacturer. Fig. 7 3. After cleaning, relieve water pressure from tool before disconnecting hose. -
Page 8: Machine Maintenance
OPERATION MACHINE MAINTENANCE MONTHLY MAINTENANCE (Every 80 Hours of Operation) 1. Lubricate wheels with water resistant oil. To keep machine in good working condition, simply 2. Inspect machine for water leaks and loose follow machine’s daily, weekly and monthly hardware. maintenance procedures. -
Page 9: Trouble Shooting
OPERATION TROUBLE SHOOTING PROBLEM CAUSE SOLUTION Machine does not operate. Faulty switches or wiring. Contact Service Center. Faulty power cord. Contact Service Center. Building circuit breaker tripped. Reset Breaker. Solution pump does not operate. Faulty switch or wiring. Contact Service Center. Faulty solution pump motor. -
Page 10: Specifications
OPERATION SPECIFICATIONS Model REXX 120 LENGTH 660 mm (26 in) WIDTH 341 mm (13.43 in) HEIGHT 698 mm (27.5 in) WEIGHT 20.0 Kg (44.5 lbs) SOLUTION TANK CAPACITY 16 L (4.2 gal) RECOVERY TANK CAPACITY 14.2 L (3.75 gal) SOLUTION PUMP 120 V, 4.13 bar (60psi), .7A VACUUM MOTOR –... -
Page 11: Electrical Diagram
ELECTRICAL DIAGRAM 120 V WIRING DIAGRAM SPP-32321 REXX 120 (03-01) -
Page 12: Parts List
PARTS LIST REXX 120 SPP-32321 REXX 120 (03-01) - Page 13 PARTS LIST REXX 120 PART # DESCRIPTION QTY. PART # DESCRIPTION QTY. B-11.2 6-32 X 3/4 FHXSS 100 DEG J-30 LID, DOME EDGE B-17.2 8-32 X 1/2 PHXSS J-38.5GRNGRNT SOLUTION TANK, ROTO GRN GRNT B-17.6 8-32 X 3/4PHX ZINC J-39.5GRNGRNT HNDL,WASTE TNK SPHR ROTO GRNGRNT CM B-21.5 10-32 X 3/8 FHXSS 100 DEG...
- Page 14 PARTS LIST PUMP 60 PSI BREAKDOWN REF# PART # DESCRIPTION QTY. • 610550 PUMP SH FL 100 PSI 120V PLG 610767 PUMP HEAD 100 PSI COMP ASM • 610768 SWITCH ASM, 100 PSI SH FL • 610769 CHECK VALVE ASM, 100 PSI SH FL 610770 HEAD, PUMP DIAPHRAGM •...
-
Page 15: Options
OPTIONS 20258 ECONO FLOOR TOOL PART # DESCRIPTION QTY. PART # DESCRIPTION QTY. • H-37 B-24.1 10-32 X 3/4 PHXZINC JET, 11006 E VEE BRASS B-26.57 10-32 X 1 3/8 PHX ZINC M-16.5 HOE HANDLE,ECONO FLRTL B-28.03 NUT, 10-32 NYLOK ZINK M-16.5A "U"CLAMP,SUPP HOE HNDL EC B-40.15... - Page 16 OPTIONS LP/20208; HP/20216 FLOOR TOOL PART # DESCRIPTION QTY. PART # DESCRIPTION QTY. B-24.1 10-32 X 3/4 PHXZINC G-23.5 VALVE,KNSTN HP "S" BEND B-26.57 10-32 X 1 3/8 PHX ZINC H-02.5 BODY, TEE JET 1/4 BRASS B-28.03 NUT, 10-32 NYLOK ZINK H-03 CAP NUT, TEE JET BRASS H-18.5...
- Page 17 OPTIONS 20078B HAND TOOL PART # Description QTY. PART # Description QTY. B-05.5 4-40 X 7/8 PHXZINC GR-2-006N70 O-RING,2-006 BUNA 70DR B-07.5 NUT, 4-40 HEX ZINC NYLOK GR-2-011N70 O-RING,2-011 BUNA 70DR B-11.5 6-32 X 1 PHXZINC GR-2-013N70 O-RING,2-013 BUNA 70DR B-14.6 NUT, 6-32 HEX ZINC NYLOK H-03.5...
-
Page 18: Warranty Policy
Cleanmaster to obtain a Return Authorization, ship the part freight prepaid to Cleanmaster and, Cleanmaster will either repair or replace the part at no charge if it is determined that failure was a manufacturing defect. Cleanmaster will then ship the repaired or replaced part back to you freight collect. Our service department can usually talk a person through any part replacement procedure in a matter of minutes. - Page 19 Cleanmaster’s control. In no event shall Cleanmaster be liable for loss of use, incidental or consequential damages or any damages to persons or property.
- Page 20 Cleanmaster’s control. In no event shall Cleanmaster be liable for loss of use, incidental or consequential damages or any damages to persons or property.
Need help?
Do you have a question about the Rexx 120 100-600-120 and is the answer not in the manual?
Questions and answers