Advertisement
Component Specifications
To avoid risk of electrical shock that can cause death or severe personal injury, disconnect unit from power
before servicing unless tests require power. Discharge capacitors through a 10,000-ohm resistor before
handling. Wires removed during disassembly must be replaced on correct terminals to ensure proper grounding
and polarization
Component
Compressor run capacitor
Compressor
Electric damper control
Thermistor
Condenser motor
Evaporator fan motor
Overload/Relay
Thermostat (Defrost)
Evaporator heater
Control board
Auger Motor
Water Valve
Light switch
Light switch / Interlock
Solenoid (Ice Chute)
16026983
!
Specifications all parts
115VAC/60HZ unless noted
Volt .....................................................
Capacitance ......................................
BTUH .................................................
Watt ...................................................
Current Lock rotor ..............................
Current Full load ................................
Resistance Run windings...................
Resistance Start windings..................
Maximum closing time .......................
Temperature Rating ...........................
RPM ...................................................
Temperature
77°F....................................................
36°F ...................................................
0°F......................................................
Rotation (facing end opposite shaft)
RPM..........................................
Watt....................................................
Current ...............................................
Rotation (facing end opposite shaft)
RPM..........................................
Watt...........................................
Note: Fan blade must be fully seated
on shaft to achieve proper airflow.
Ult. trip amps @ 158°F (70°C) ...........
Close temperature ...........................
Open temperature ............................
Short time trip (seconds)....................
Short time trip (amps @77°F (25°C) ..
Volt ....................................................
Watt ...................................................
Current ...............................................
Resistance across terminals:
Above 42°F ±5°..................................
Below 12°F ±7° ..................................
Volt.....................................................
Wattage..............................................
Resistance .........................................
Volt.....................................................
Rotation (facing end opposite shaft)
RPM ...................................................
Watts..................................................
Type............................................
Volt.............................................
Current.........................................
Type............................................
Volt.............................................
Current.........................................
Resistance across leads ....................
WARNING
220 VAC
15 μfd ± 10%
905 BTUH
60 Hz / 153 watts
19.0 amps± 15%
1.26 amps± 15%
3.33 ohms± 15%
4.28 ohms± 15%
8 seconds
20°F- 110°F
5
Resistance
10,000 ohms± 1.8%
29,500 ohms± 1.0%
86,300 ohms± 1.8%
Clockwise
1120 RPM
3.4 watts±15%@115VAC
0.085 amps± 15%@115VAC
Clockwise
2800 RPM
5.9 ±15% watts@115VAC
2.40 amps± 15%
140°F ±10°F
230°F ±5°F
17 seconds ±5
12 amps ±2amps
120/240 VAC
475 watts
10/5 amps
Open
Closed
115 VAC
450 ±5% watts @ 115VAC
29 ±7.5% ohms
120VAC, 60 HZ
See Control board troubleshooting section
Power to blue and white is clockwise. Power to
orange and white is counterclockwise.
17± 3 RPM
Brown side 35w,Yellow side 20w
SPST NC
125/250 VAC
8/4 amps
SPDT NO/NC
125/250 VAC
8/4 amps
101ohms ± 10%
2
February 2006
© 2006 Maytag Services
Advertisement
