Pro Control Pro24.z Quick Reference Manual

®
Programmable
"soft buttons" for
custom touchscreen
labeling
Charging LED
USB Port
Pro24.z
Installing and Recharging the Battery
Quick Reference Guide
The Pro24.z uses a Lithium-Ion rechargeable battery that does not exhibit any type of "Memory Effect" from being charged
71-500000-13 V1.0
too often. The remote features convenient USB recharging capability, giving you even more control over how and where you
choose to recharge the remote's battery.
IR LED emitters
The Pro24.z comes equipped with:
• One (1) standard USB programming cable (one Type A USB end and one micro USB end)
and IR Learning
• One (1) micro USB-powered recharging cradle
Photodiode
• One (1) 5VDC universal AC adapter (integrated micro USB cable)
• Four (4) interchangeable AC adapter plugs for international applications
240 X 320 pixel TFT
LCD touchscreen
Access Door
Programmable
5-way joystick
To recharge the Pro24.z follow either one of the methods listed below.
NOTE: 3rd party AC Adapter cables may not fit properly and
could result in damage to the unit. Only use the supplied
cable.
Method A
• Insert the micro USB end of the AC Adapter cable into the USB
port located on the bottom-side of the remote control unit.
• Plug the AC Adapter into a wall outlet.
• The Charging LED on the bottom of the unit will flash while the
battery is charging, and it will solidly illuminate when the
charging cycle is complete.
Programmable
"hard buttons" for
tactile control of
commonly used
functions
Power Switch
Lithium-Ion
Battery Pack
Battery Lock
A
OR
To Wall Outlet
Method B
Follow the steps below to install/access the rechargeable
Lithium-Ion battery.
1 Remove the access door from the rear of the
remote by sliding it down and off.
2 Orient the battery so that the charging contacts
point toward the top of the remote, and insert the battery
into the battery compartment.
3 Ensure that the battery's charge contacts are
touching the charging pins inside the battery
compartment.
4 Press the battery down into the compartment until it
snaps and locks in place. Turn the unit on
by sliding the power switch located above the
battery compartment to the "ON" position.
5 The battery can be removed by pressing the battery
lock down and lifting the battery out of the battery
compartment.
To Wall Outlet
• Place the Pro24.z in the recharging cradle.
• Insert the micro USB end of the AC Adapter cable into the USB
port located on the topside of the recharging cradle.
• Plug the AC Adapter into a wall outlet.
• The Charging LED on the bottom of the unit will flash while the
battery is charging, and it will solidly illuminate when the charging
cycle is complete.
® Get more control
®
B
Pro24.z Recharging
Cradle