Advertisement
1. DISASSEMBLY
1-1.
REMOVAL OF CABINET, MECHANISM
UNIT, AND MAIN BOARD
REMOVING
THE CABINET
PARTS (Fig. 1-1-1 )
1.
Spread
out the lock clamps
(C) In the arrow dlrectlon
1.
Remove the cabinet and bottom cover by removing the four
slightly and remove the TM-1 PWB as shown in Fig. 1-1-2.
screws @ and four screws @J.
2.
Remove the screw (1; at the back of the chassis.
2.
Remove the front panel by removing the locks of the clamps
3.
Remove the red screw @ in the chassis, remove the red
(A) using a screwdriver, etc. and slightly rotating the bottom
screw .6;, and remove the holder 1 in this order.
part in the direction of the arrow.
4.
Remove the holder 2 by removing the screw ~.
5.
Remove
the two screws @ and two screws
@ of the
Notes:
Electrical
adjustments
for the this model can be
mecharusm unit, The two screws @of the cassette tray can
performed with only the cabinet removed.
be removed easily by pushing the tray lock lever in the
When replacing the bottom cover, do not tighten the
arrow direction to remove the lock as shown in the enlarge
screws @ too much. Excess tightness may damage
view A and by pushing the lid opener lever in the arrow
the screws taps on the chassis.
direction to remove the lock as shown in the enlarge view
B.
REMOVING
THE MECHANISM
MAIN UNIT AND THE
6.
Lift up the whole mechanism
unit and main board (CP-1
CP-1 PWB ASSEMBLY
(Fig. 1-1-2 and l-l-3)
PWB assembly), and as shown in Fig. 1-1-3, push the two
lock clamrxi (D) of the chassis in the arrow direction so that
After removing the cabinet parts, remove the mechanism
unit
.,
they can be removed from the chassis,
and the CP-1 PWB assembly connected as follows.
.-
L
M-PP21G5.I
Front Panel
Unit
ver
Fig. 1-1-1
–'5 –
Advertisement
