Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Portland Willamette Electric fireplace
Summary of Contents for Portland Willamette Electric fireplace
- Page 1 Electric Fireplace Instruction Manual Electric Fireplace Packing List Electric Fireplace Trim Kit Remote Control AAA Batteries Fastener Package (Wall unit only) Wall Fixing Plate (Wall unit only) Portland Willamette www.portwill.com 1-800-288-7511...
-
Page 2: Installation Instructions
INSTALLATION INSTRUCTIONS Location 1. The fireplace must not come in contact with any combustible materials. 2. The heater must be a minimum of 16 inches away from any combustible material. 3. It is important that the wall on to which the fireplace is to be installed is of sound construction. - Page 3 Installation Wall Unit 1. Select the position of the fireplace on the wall to which it is to be mounted. Draw a level horizontal line on the wall at the required height. This line will correspond to the top of the fireplace so it is important to allow for the extra height of the glass face.
- Page 4 7. Lift the fireplace and place the keyhole slots situated on the back of the fire (Figure 2) to the location pins on the mounting plate. A gentle application of downward pressure will lock it into place. Make sure both of the pins have been located into the top section of each keyhole fixing slot.
- Page 5 Installation Insert & Stand Alone Set into place & attach face with magnets provided. Warning: To access controls behind louver open from the sides, the center of the louver may be hot. P a g e...
-
Page 6: Electrical Work
MUST be replaced. 11. The fireplace must not be modified in any way or used for purpose other than those recommended by Portland Willamette. 12. If the fireplace shows any signs of damage it is important that it is examined by a qualified professional before use is continued. - Page 7 Attaching the Face Wall Unit Only Two people may be required to carry out this installation 1. On each side of the fireplace are two locating studs (Figure 5). 2. On the back of the face there are two brackets which hook over these studs. 3.
-
Page 8: Operating Instructions
OPERATING INSTRUCTIONS CAUTIONS: 1. When the fireplace is in operation, certain areas of the fireplace surface will get hot. Caution must be taken to avoid being burned. Refrain from touching hot surfaces of the appliance. 2. The fireplace must not be switched on if volatile vapors are present in the room. -
Page 9: Remote Control
Fireplace Control Panel The control panel is located on the right hand side of the fireplace Figure7 A Main Power Switch B On/Off Switch C Flame Effect Dimmer Switch D Heater Maximum Heat 1500 w E Heater Low Heat 750 w Remote Control DIMMER ON/OFF HIGH\LO W A Infrared Window... - Page 10 3. To enable the remote control to function the power to the fireplace must be switched on. 4. At a distance of 5 to 6 feet, point the remote control directly towards the bottom right hand side of the fireplace. (Figure 9) B On/Off Switch: Press on/off switch to turn fire on.
-
Page 11: Maintenance Instructions
MAINTENANCE INSTRUCTIONS Changing Light Bulbs Disconnect power supply before beginning any maintenance. WARNING • Allow at least five minutes for the light bulbs to cool before touching the bulbs to avoid burning. Make sure power supply is disconnected. • Examine the bulbs to determine which one needs replacing. Remove the non working bulb and replace with a new long life bulb. - Page 12 Warranty Portland Willamette’s products are warranted only to the original retail purchaser-user to be free from defects in material and workmanship at time of purchase for 2 years. Consumable items are not covered. PORTLAND WILLAMETTE DISCLAIMS ALL OTHER WARRANTIES, WHETHER EXPRESS OR IMPLIED, AND SPECIFICALLY DISCLAIMS THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
Need help?
Do you have a question about the Electric fireplace and is the answer not in the manual?
Questions and answers