Related Manuals for REX RELICSCAN
Summary of Contents for REX RELICSCAN
- Page 1 Metal Detectors “R E L I C S C A N” Professional pulse induction metal detector User’s guide ________________________________www.rexmetaldetectors.com_________________________________ made in Bulgaria...
- Page 2 1. Assembling of the device: Assembling the Relicscan is simple and you don’t need any special tools. When use the round coil 14” (36cm.) or 18” (45cm.): The bearing rod is assembled by inserting of the lower part into the upper one.
- Page 3 In order to avoid interference of the metal parts of the electronic unit, be sure to carry the Relicscan on the side of your body that is away from the search frame. 1. Turn on the detector: Searching frame is assembled and is placed on the ground paying attention to the range and there don't have to be any metal objects.
- Page 4 Hold for a few seconds the coil / frame above the ground. If the sound signal is changed (increased), lower values of THRESHOLD carefully, until the sound signal disappears or stays to hear the sound "pop" with a low frequency. The Relicscan is tuned and ready to use on ALL METAL mode.
- Page 5 Thus the signal from the detected object becomes much shorter. “Relicscan” can sometimes react by small objects such as big coins or large caps, if they are on the earth surface and within just pass over them, but then hear a short sound of a double crossing of the two arms of the frame over the subject search! “Relicscan”...
- Page 6 “Relicscan” can work with different types of coils and frames 1x1m. frame / 1,25 x1,25m / 1,5 x 1,5m. / 2x2m. and smaller round coils - 36cm. and 45cm. Search frames are used for the detection of large and bulky metal objects deeply buried to about 5-6 meters., A small round...
-
Page 7: Switched Off
5. Battery charging and indications for their status. “Relicscan” has a built-in accumulator battery 12V/2,2Ah, which is able to provide 15-18 hours of working process without any interruption depending on the type of the used search coil. - Page 8 “+” and “-” because the use of other chargers or adaptors may lead to irretrievable damages in the batteries! 6. Possible problems during exploitation of “Relicscan”: 6.1. When switching it on you can not hear a sound, there is no information on the display, no indication that the device is switched on.
- Page 9 (office) of the company manufacturer or the local distributor for change of the storage batteries. In case that the Relicscan has been exposed to low temperatures, you should absolutey avoid an abrupt warming. The condensation humidity can provoke a disturbance of function.
Need help?
Do you have a question about the RELICSCAN and is the answer not in the manual?
Questions and answers