Table of Contents
Advertisement
JR 11X SYSTEM
WITH SPEKTRUM 2.4GHz DSM TECHNOLOGY
INSTRUCTION AND PROGRAMMING MANUAL
The JR11X offers sophisticated programming
features for three model types: airplanes,
helicopters and sailplanes. This manual
includes a section of common transmitter
features and overall operational information,
a section of model-specific programming and
an appendix.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Horizon Hobby JR 11X
- Page 1 JR 11X SYSTEM WITH SPEKTRUM 2.4GHz DSM TECHNOLOGY INSTRUCTION AND PROGRAMMING MANUAL The JR11X offers sophisticated programming features for three model types: airplanes, helicopters and sailplanes. This manual includes a section of common transmitter features and overall operational information, a section of model-specific programming and...
-
Page 2: Table Of Contents
NOTICE Dual Channels ....................16 Aileron to Elevator/Elevator to Aileron Mix .............28 All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. Twin Engine ....................17 3D Electronic Cyclic Ring (E-Ring) ..............28 For up to date product literature, visit http://www.horizonhobby.com and click on the support tab for this product. - Page 3 • ALWAYS connect the center pin of y our JR transmitter to the negative pole for correct polarity. With Spektrum’ s 2.4GHz DSM technology, the JR 11X offers a hassle-free, The 11X features Advanced digital trims. On the Normal display screen, if you interference-free superior RF link for your airplane, helicopter or sailplane.
- Page 4 The blue light on the top front of the transmitter will also be on solid indicating the system is outputting signal and operating. JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL...
- Page 5 Do not attempt to use the antenna to bear any weight, pick up the transmitter by the antenna or alter the antenna in any way. If the transmitter antenna or related components become damaged the output strength can be severely impeded which will likely lead to a crash, injury, and property damage. JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL...
- Page 6 All functions in the System List and Function List are back to the original model memory. You can restore the original settings any time. the Quick Information Screen appears. available to place into My List. JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL...
- Page 7 The TX Settings program allows you to turn the screen backlight on/off/or place it 2 Highlight HELI and press the Roller to access HELI mode. in auto (sleep) mode. This function also allows you to turn the audible beeper on JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL...
- Page 8 Slave transmitter will be used. Plug the Trainer cord into the • Assign Switch, Lever and Knob assignments back of the transmitter leaving the power switch in the OFF position. • Activate/inhibit switches/channels JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL...
-
Page 9: Dual Channels
NORMAL wing type. Also use NORMAL if the aircraft has flaps separate from the ailerons. If using two aileron channels, activate the Dual aileron channel listed below. JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL... -
Page 10: Swashplate Type
Normal. To access Reflex or Thermal, the Launch switch must be in the middle to one of the following switches: Flight Mode, Rudder D/R switch, Elevator JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL... -
Page 11: Servo Reversing
4. Highlight the desired point (L, 1, or H) and press the roller to access the or +/-. 3 Move the Roller and highlight the desired throttle point to be adjusted. Press JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL... - Page 12 Mode, or select SW for the Flap switch to control the flaps. point value, then adjust the desired value. To reset original settings, highlight a point value then press CLR. JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL...
-
Page 13: Differential
4. Scroll down to the bottom line of the display to select the Flight Mode and/ Elevator is applied. or switch(s) to turn the mixer on and off. The example below shows Flight JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL... - Page 14 Hold. appears on the left bottom of the screen. Press STOR to save a new point at that position. JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL...
- Page 15 Roller to access the Slide Camber for the intended flight mode and press the neutral position. You can program the flap functions to one of many different elevator and pitch) from overdriving when you give a command of full elevator roller. JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL...
-
Page 16: Flaperon Mix
Press the Roller to access the Flaperon Mix menu. off and on via a programmed switch, Stick position or flight mode. The Snap Roll/ +200. Negative values move the offset in the up-elevator direction. JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL... -
Page 17: Functions Of The Standard Programmable Mixer
Offset and the switch is in a To change the value of a point, highlight and select the point name then dial in the position to select the Pos0 values. desired percentage. JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL... -
Page 18: Slave Channel Position
Lag. The value ranges from INH to 2.0 seconds. turn the mixing on or off for each of the active flight modes. abruptly when switching from tail lock to normal mode. JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL... -
Page 19: Stick Position Switch
2 Highlight and select INH under TIMER1, TIMER2 or TIMER3 then select ON. Expo will apply a curve response between the points selected. DOWN-T of STOP W. Use the Roller to set the countdown set time, interval, JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL... -
Page 20: Frequently Asked Questions On Spektrum 2.4Ghz
JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL... -
Page 21: Warranty And Repair Policy
Product immediately in new and warranties, express or implied. Notice: Do not ship batteries to Horizon Hobby. If you unused condition to the place of purchase. have any issue with a battery, please contact the appropriate... -
Page 22: Advanced Range Testing
(JRPA040-JRPA045). These stick ends are crafted from bar stock aluminum, and are available at your local JR dealer. Neck Strap Attachment The face of the 11X transmitter has an eyelet for connecting a Neck Strap. JR 11X • RADIO INSTRUCTION MANUAL JR 11X • RADIO INSTRUCTION MANUAL... - Page 23 © 2010 DSM and DSM2 are trademarks or registered trademarks of Horizon Hobby, Inc. 4105 Fieldstone Road, Champaign, IL 61822 USA US patent number 7,391,320. Other patents pending. The Spektrum trademark is used with permission of Bachmann Industries, Inc.
Need help?
Do you have a question about the JR 11X and is the answer not in the manual?
Questions and answers
How to turn RF on?
To turn on RF for the JR 11X transmitter, plug the Trainer cord into the back of the transmitter while leaving the power switch in the OFF position. This activates the transmitter for training or programming without turning on the RF signal. To turn on RF normally, simply power on the transmitter using the power switch without the Trainer cord connected.
This answer is automatically generated
How to turn RF
@John Langridge