GMC Motorhome 1976 Operating Manual page 53

Table of Contents

Advertisement

HOT WATER FAUCET
CO LO WATER FAUCET
SHOWER CONTROL VALVE
Bathroom Sink (ZEO 6581)
and also by not adding volume to your holding
tank. The toilet operates on 12-volt DC.
OPERATING PROCEDURES
Initial Flush Charge
1. Be sure handle on dump valve is pushed in.
2. Open fill valve, filling toilet to the charge
level as indicated by the letter ''C" on prism.
This will be approximately 3 gallons. Close the
fill valve.
3. Add recirculating toilet chemical as rec-
ommended by manufacturer of chemical.
To Flush
Depress flush button. Timer will provide a
seven second flush
cycle.
To Empty Toilet Into Holding Tank
1. When prism indicator shows level at the
letter "F" it is time to empty the toilet. When
full,
toilet holds approximately seven
gailons.
The toilet may also be emptied when the blue
chemical solution turns green as this is an
indi-
cator that the active ingredients are used up.
2. Pull the dump handle all the way
out.
The
handle is located near the floor at the center of
the front of the toilet. When toilet is empty, as
indicated by the
prism,
push the handle back in
and recharge toilet as directed under "Initial
Flush Charge" described
previously.
CLEANING TIPS
1. There are several excellent cleaning
com-
pounds that may be
used.
Be sure to read the
47
Shower Head (Typical)
label to be sure compounds will not damage
plastic parts and tubing.
2.
Recreational users advise it is best to flush
the toilet before each use to aid in maintaining
cleanliness.
3. Another aid to flushing is to lay some
toilet tissue in the bowl just prior to use.
BATHROOM SINK AND SHOWER
CONTROL VALVE (ZEO 6581}
The
MotorHome
Model ZEO 6581 bathroom
sink has the shower control
valve
built into the
spout.
With the shower control valve knob pushed
in, the off position, water temperature may be
adjusted prior to t aking a shower. Once the
de-
sired temperature is set, remove the shower
head from the wall and point towards the sink.
Open the valve at the shower
head,
puii the
shower control valve knob out and allow water
to flow into sink until it
warms
to the desired
temperature.
Adjustments in temperature may
be made as required.
Showers can take a lot or a little
water.
A
suggestion would be to take a "camper's"
shower.
Wet yourself down, then turn off the water at
the shower
head,
soap up and then turn water
back on to
rinse.
NOTE: Remove shower drain plug before
taking a shower. Shower drain plug should be
installed when shower is not in use.

Advertisement

Table of Contents
loading

Table of Contents