Advertisement
Quick Tips
Revised September 23, 2002
S E A T S
Seats
1. Fore/aft adjustment
Raise lever and hold, slide
seat, release lever
2. Seatback angle*
To adjust: Lift and hold lever,
lean forward or backward
to tilt seat, release lever
3. Manual lumbar control*
Rotate clockwise/counter
clockwise to increase/decrease
firmness
WARNINGS: Do not adjust
seats while driving
Safety belts must always
be worn when vehicle
is in motion
All air bags are supplemental
and do not replace safety
belt usage
Always wear your safety belt
and properly secure children
Child-safety seat
To install, use dual-locking mode
retractor safety belts; see Owner's
Manual for proper installation
and child seat tether and
LATCH system instructions
WARNING: Use age
appropriate child restraints,
see Owner's Manual and
state or province laws
Always check the Owner's Manual for more operating information and safety features
Mazda
Seats
Shoulder belt
height
adjustment
To raise belt:
Slide adjuster up
To lower belt:
Push release
button (4) and
slide down
WARNING: Make
sure adjuster locks
in one of its
3
positions
1
Passenger's
front air bag
OFF
deactivation
ON
OFF
switch
Deactivate
PASSENGER AIR BAG
passenger's
front air bag
when using a child-safety seat
To deactivate/activate: Insert
ignition key in switch, rotate
to OFF/ON, remove key
Amber OFF light illuminates when
deactivated and ignition is on
Tip: Turn ignition off when
disabling passenger front air bag
WARNINGS: When using a
rear-facing infant-safety seat
always set the passenger seat
air bag deactivation switch to
OFF position, an infant is in
serious danger of being injured
or killed if front passenger air
bag is deployed
Seats/
Console
Mazda Truck
Dual locking mode
4
lap/shoulder belt retractor
(passenger only)
Emergency locking mode: Belt
locks only on hard braking/
cornering or impacts of about
5 mph or higher
Automatic locking mode: Must
be used when installing child-
safety seat
To activate: Pull webbing fully
out of retractor; belt will only
tighten
To disengage: Unbuckle belt
and allow webbing to retract
fully, for complete details see
Owner's Manual
2
If you install a front-facing
child-seat, put it in the outboard
seat and slide it all the way
rearward
For Cab-Plus vehicles, do not
put child restraints in the center
facing jump seats, for complete
details see Owner's Manual
1
Console (Split bench)
1. Coin tray
2. Map storage
3. Storage compartment
*Denotes optional equipment
page 8
page 9
2
3
Advertisement
