Cisco LINKSYS DMP100 Quick Installation Manual page 89

Supplemental Information Regulatory
Please check the CE mark on the product label to find out which notified
body was involved during assessment.
National Restrictions
In the majority of the EU and other European countries, the 2.4 GHz
and the 5.0 GHz bands have been made available for the use of wireless
local area networks (LANs). The table labeled IIOverview of Regulatory
Requirements for Wireless LANs" provides an overview of the regulatory
requirements applicable for the 2.4 GHz and the 5.0 GHz bands.
The requirements for any country may evolve. Linksys recommends that
end-user check with the local authorities for the latest status of their
national regulations for both the 2.4 GHz and the 5.0 GHz.
Overview of Regulatory Requirements for Wireless LANs
Max. Power Level Indoor&
Frequency Band (MHz)
EIRP (mW)
Indoor Only Outdoor
2400-2483.5 100
X
5150-5250 200
X
5250-5350t 200
X
5470-5725t 1000
X
tDynamic Frequency Selection (DFS) and Transmit Power Control (TCP) are
required in the frequency ranges of 5250-5350 MHz and 5470-5725 MHz.
Dynamic Frequency Selection (DFS) and Transmit Power Control (TPC)
are required for operation in the 5.0 GHz band.
DFS: This function is required by the national regulations to avoid
interference with the Radio Location Services (radars) when operating in
the 5.250-5.350 GHz & 5.470-5.725 GHz bands.
TPC: For operation in the 5.0 GHz band, the maximum power level is 3
dB or more below the applicable limit. As such, TPC is not required.
This product contains a wireless-N, -G, -B, and/or -A transceiver,
intended for use in all EU countries, and all other countries following EU
directive 1999/5/EC, without any limitation except for any country listed
in the restriction of use below:
Wireless-N Music Extender
13