Advertisement

Air purifier/humidifier
Axair PH7

Operating Instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PH7 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Axair PH7

  • Page 1: Operating Instructions

    Air purifier/humidifier Axair PH7 Operating Instructions...
  • Page 2: Table Of Contents

    Contents Introduction Important notes Intended use Safety instructions Notes on the Operating Instructions Product overview Design Functional description Unpacking, checking the delivery and removing the transport lock Notes on correct location Operation Maintenance and cleaning Maintenance intervals Maintenance Disposal What if...? Technical data Spare parts list...
  • Page 3: Introduction

    Operating Instruc- where they will be at hand whenever you need them. tions of the Axair PH7. Any improper use of the unit is If the Operating Instructions are mislaid, please contact strictly forbidden.
  • Page 4: Product Overview

    Note: If the Axair PH7 is operated without water it works as air purifier only and no humidification takes place.
  • Page 5: Notes On Correct Location

    4. Thoroughly rinse the water tank and the level regulating valve with hot water, then fill the water tank with cold tap – Do not locate the PH7 close to cold outer walls and do water. Do not use additives.
  • Page 6 (see section “Refilling the water tank”). Recommendation: for optimum purification the Axair In case you want to put the Axair PH7 out of operation for an PH7 should always be operated with water. As an extended period: exception to the rule, the unit may be operated without •...
  • Page 7: Maintenance And Cleaning

    In case you have to use cleaning or deliming agents strictly adhere to the relevant application notes and safety instructions. 1. Switch the Axair PH7 off, remove the mains plug from • Hood, fan housing, air intake screen and tank base the wall outlet and wait until the fan comes to a stop.
  • Page 8 Reassembling the unit able deliming agent (e.g. acetic cleaning agent or 8- percent formic acid), then rinse thoroughly with fresh Caution! Before reassembling the Axair PH7 check water. all components for possible damage. Do not reuse If there is no formation of lime, clean the parts with luke-...
  • Page 9: Disposal

    Please observe the local regulations for correct disposal of the entire unit or particular components . If in doubt, consult your Axair supplier. 6. Fold the activated charcoal vaporizer mat (as shown in the figure above), then insert the mat into the base tub.
  • Page 10: What If

    On/Off key. mains failure. the mains supply checked. Wrong mains voltage. Check main voltage. Unit is defective. Contact your Axair supplier. Unit is operational but emits a Fan housing mounted incorrectly. Mount fan housing correctly. brushing sound. Impeller improperly located.
  • Page 11: Technical Data

    Technical data Axair PH7 Axair PH7 Plus System Air cleaning: three-layer filter with activated charcoal Hepa filter with activated charcoal Air humidification: cold evaporation Dimensions (W x H x D) 590 x 382 x 383 mm Weight 5.7 kg (dry)
  • Page 12: Spare Parts List

    2-step, 100 V 1118673 Activated charcoal vaporizer mat 1118615 3-step, 230 V 1118674 Hood, large 1118664 3-step, 100 V 1118675 Impeller cpl. 1104377 Hood, small 1118663 Support 1118661 Keypad 2-step (PH7) 1118678 1118665 3-step (PH7 plus) 1118679 Motor support 1118662...
  • Page 13 Notes...
  • Page 14 Consulting, Sales and Service: Reg.No. 40002-2 Manufacturer: Axair Ltd. Systems for Air Treatment A WMH Walter Meier Holding Company CH-8808 Pfäffikon (Switzerland), Talstr. 35-37, P.O. Box Telephone +41 55 416 61 11, Fax +41 55 416 62 62 Internet http://www.axair.ch, E-Mail info@axair.ch...

Table of Contents