AquaVaporCig MyGo User Manual

AquaVapor Cig MyGo Variable Voltage eCig
Thank you very much for purchasing the AquaVaporCig MyGo. We have two version of the MyGo Variable Voltage Electronic
Cigarette. You can determine the version you have by the material used on the end cap that screws off to insert battery into
housing. If your device has a plastic end cap you have a V1 MyGo if the cap is metal and the display has a battery charge indicator
bar your device is a V2 MyGo. Based on your version the device will have slight differences which are described below.

V1 Functions

1) Adjust the voltage from 3v to 6v by pressing the + of - button, the higher the voltage the more vapor produced.
2) Short circuit self-protection. When atomizer resistance is below 1.3ohm, or incorrect usage (such as reverse battery) leading
to short circuit, the device will turn itself off.
3) The max working current is up to 1.5 amps. But we limit the Atomizer Resistance to 1.3ohms, if below 1.3 Ohms the device
will turn itself off.
4) Regulated output which keeps the voltage the same with each puff - regardless of your remaining battery power. As the
battery drains, the device will keep the voltage consistent.
5) Vent hole on the bottom cap of the device for added safety.
6) Turn the device on and off by holding down the power button for 5 seconds.
7) Check the remaining battery voltage by pressing the power button 7 times consecutively within 3 seconds.
8) Lock in the selected voltage by holding down the + and – button simultaneously for 5 seconds. Unlock by doing the same. This
is useful for when you find your desired voltage and don't want it to change if the voltage buttons are accidentally pressed.

V2 Functions

1) Adjust the voltage from 3v to 6v by pressing the + of - button, the higher the voltage the more vapor produced.
2) Short circuit self-protection. When atomizer resistance is below 1.3ohm, or incorrect usage (such as reverse battery) leading
to short circuit, the device will turn itself off.
3) The max working current is up to 3.5 amps. But we limit the Atomizer Resistance to 1.3ohms, if below 1.3 Ohms the device
will turn itself off.
4) Regulated output which keeps the voltage the same with each puff - regardless of your remaining battery power. As the
battery drains, the device will keep the voltage consistent.
5) NEW - Metal caps for both top and bottom for added durability.
6) NEW - Larger 3mm Vent hole on the bottom cap of the device for added safety
7) NEW - When you use a voltage meter or testing tool to test the voltage, there will be only 0.2v voltage difference between the
voltage without load (without atomizer attached) and the voltage under load (with atomizer attached).
8) NEW - Turn the device on and off by pressing the power button 5 times within 3 seconds.
Page 1 of 5