Table of Contents
Advertisement
The following procedure
is only necessary if no AV connection
is made. With an AV connection,
simply switch the TV receiver
to "AV mode when using the VCR.
Set the TV receiver to channel O or
1 (2 or
3...for New
Zealand).
(Choose the channel that is not used for
broadcasting
in your area.)
Then set the channel selector switch, on the rear of the
VCR, to the "CH O" or "CH
1"("CH
2 or CH 3"...for New
Zealand) position, corresponding
to the channel
selected on the TV receiver.
Press the VTFUTV select button to display
"VTR"
on the
VCR display.
Select, on the VCR, an active channel by pressing the
-.
(A
or V) button, or with the numeric buttons. Or, play
back a prerecorded
tape.
Adjust the channel tuning control on the TV (or fine
tuning control) to the point at which the picture and
sound are best.
When using the VCR, set the TV receiver to this channel
(channel O or
1
...for Australia, channel 2 or 3 ...for New
Zealand). This will be the video channel.
"yl,
00
,.
0 0
[
f
aD
The videb channel
Australia...O or 1
Ei
New Zealand...2 or 3
8
Advertisement
Table of Contents
