Safety Information - WindStream Technologies SolarMill SM1-1P User Manual

WindStream Technologies

Safety Information

WARNING: Hazardous voltages, currents, or other conditions that could cause serious bodily injury or
death exist in the equipment or may be associated with its use.
Fast moving parts. Do not install this device in a location accessible to children and/or pets.
ONLY qualified personnel such as a WindStream Technologies' employee, Authorized installer, licensed
contractor, or WindStream certified engineer should install the TurboMill or system of TurboMills.
The installation must be installed following the guidelines established by state and local regulations.
Consult a local electrical contractor, the local planning and zoning office and local Electric Utility for
details and regulations. This manual is not intended to be used for the installation of this product but
to serve as an overview of the Turbomill, it's functionality, hook-up and maintenance. The SolarMill
Technical Guide is required to properly install this product.
Once installed, use caution when approaching the device. The rotating turbines can present a serious
threat that can cause injury, even at low speeds.
WARNING: Never touch the rotating turbines.
WARNING: Never try to stop the turbines by hand.
Warranty related
The warranty and safety are dependent upon the proper installation of the product.
Installations not performed by qualified personnel will not be covered under WindStream
Technologies' limited warranty .
Turbines must not be allowed to turn until the low voltage bus is connected to charged batteries.
Turbines should be secured if the voltage drops below 30 VDC to avoid damage to the electronic
controller.
User Guide V2.01 Rev 11.3.13 7