Before the Operation
System installation
Voltage rating (as the picture -01)
1
)
This product use for the vehicle with 12V battery and negative GND. Before
the installation, check the battery voltage.
2
In order to avoid short-circuit system, installed prior to the proposed removal
)
of the battery negative.
3
Don't cross the fuse of the device,
)
directly connect to the battery.
The installation of the device
1 First of all, take the original vehicle CD player out.
)
2 Remove the install bracket and screws and keep it.
)
3 Fix the bracket through the screws on the navigation system device.
)
4 Don't connect this product power wire directly to other power-line circuits.
)
5 Fix all the cables according to the hose diagram.
)
6 Install the navigation system in right position and then screw the bracket of the
)
original car to fix it well.
Note:
Do not damage or dirty the Dashboard.
(Picture-01)
5
The installation of GPS antenna
1) To install the antenna in the inner of
the car(on the rear shell),please try to make
the metal plate stick on the horizontal lever
so that the GPS antenna towards the
window. GPS antenna will be placed on the
metal plate. ( GPS antenna fixed by
magnetic.) picture 02
(
-
):
NOTE:
Paste the metal plates, should not be cut it into small pieces. Some models
of vehicles do not allow glass windows GPS satellite signal penetration. Then,
the GPS antenna should be installed at the outside of the vehicle.
2 To install an external antenna (on the
)
car),GPS antenna will be placed in a level
position as far as possible, such as roof or
cover suitcase Department. ( By a fixed
magnetic body.) picture 03
(
-
):
6
Before the Operation
metal plate please peel
GPS antenna
the paper at back
please sweep t he
place to make sure
no dust,wet,oil o r d irt
N
OTE he metal plate
:
t
before you stick.
have powerful glutinosity to
leave the impress when y ou
remove it.
(Picture 02)
-
GPS Antenna
When t he l ead c ontacts the u p
of the car door to circle au-turn
in order to prevent the r ain w ater
flows along the lead t o t he in-
house o f v ehicle.
Waterproof mat
Please m ake s ure water-
proof mat t o contact the
top of rubber pad.
Curving t he lead to a circle
out side the rubber pad in
order t o p revent rain water
flows a long t helead vehicle
in-house.
(Picture 03)
-