Do you have a question about the Tascam M-2516 and is the answer not in the manual?
Questions and answers
ラシ
March 28, 2025
Preとpostの切り替え方がわからない
2 comments:
Mr. Anderson
March 28, 2025
To switch between pre-fader and post-fader on the Teac Tascam M-2516 mixer, follow these steps:
1. Locate the AUX send section on the channel strip. Each channel has controls for auxiliary (AUX) sends.
2. Identify the PRE/POST switch associated with each AUX send. This switch determines whether the AUX signal is taken before (pre) or after (post) the channel fader.
3. Set the switch position: - PRE (Pre-fader): The AUX send level is independent of the channel fader. Use this for monitor mixes. - POST (Post-fader): The AUX send level changes with the channel fader. Use this for effects sends.
4. Toggle the switch to the desired position for each AUX send on each channel.
Check the channel strip labeling to confirm each AUX’s PRE/POST switch.
Need help?
Do you have a question about the Tascam M-2516 and is the answer not in the manual?
Questions and answers
Preとpostの切り替え方がわからない
To switch between pre-fader and post-fader on the Teac Tascam M-2516 mixer, follow these steps:
1. Locate the AUX send section on the channel strip. Each channel has controls for auxiliary (AUX) sends.
2. Identify the PRE/POST switch associated with each AUX send. This switch determines whether the AUX signal is taken before (pre) or after (post) the channel fader.
3. Set the switch position:
- PRE (Pre-fader): The AUX send level is independent of the channel fader. Use this for monitor mixes.
- POST (Post-fader): The AUX send level changes with the channel fader. Use this for effects sends.
4. Toggle the switch to the desired position for each AUX send on each channel.
Check the channel strip labeling to confirm each AUX’s PRE/POST switch.
This answer is automatically generated
この画像の状態では何が邪魔をしているかわかりますか？