Table of Contents
Advertisement
Quick Links
INSTALLATION
INSTRUCTIONS
PARTS LIST
Cassette player
Owner's Manual
5 Washer-screws, 5 x 8 mm
Wire tie
Harness clip
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
Accessory
CASSETTE PLAYER
P/N 08A03-5C2-050
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Stubby Phillips screwdriver
Ratchet
8 mm and 10 mm Sockets
Shop towel
Diagonal cutters
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by "do-it-yourselfers."
1.
2.
3.
BII 26193 (0309)
Application
2004 RSX
If equipped, make sure you have the anti-theft
code for the radio, then write down the radio station
presets.
Disconnect the negative cable from the battery.
Pry up on the seven clips, and remove the center
lower cover. Unplug the accessory socket
connector. Take care not to damage the clips.
ACCESSORY
SOCKET
ACCESSORY
SOCKET
CONNECTOR
Publications No.
BII 26193
Issue Date
SEP 2003
CLIPS (7)
CENTER LOWER COVER
1 of 4
08A03-5C2-2001-91
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Acura 08A03-5C2-050
-
Page 1: Installation Instructions
Accessory Application Publications No. BII 26193 INSTALLATION CASSETTE PLAYER 2004 RSX P/N 08A03-5C2-050 Issue Date INSTRUCTIONS SEP 2003 PARTS LIST TOOLS AND SUPPLIES REQUIRED Phillips screwdriver Stubby Phillips screwdriver Ratchet 8 mm and 10 mm Sockets Shop towel Cassette player... - Page 2 Using a stubby Phillips screwdriver, remove the Remove the radio from the center panel bracket two bolts that fasten the center panel. (four bolts). ANTENNA LEAD BOLT (Reuse.) CLIPS (4) SELF- VEHICLE CONNECTOR TAPPING BOLT RADIO SCREW (Reuse.) POCKET BOLT CENTER PANEL BRACKET CENTER PANEL SELF-TAPPING...
- Page 3 Stack the radio on top of the cassette player, and 12. Reinstall the hazard switch using the two self- slide them into the center panel bracket. Install tapping screws you removed in step 6. the radio with the four bolts removed in step 7, and install the cassette player with four 5 x 8 mm washer-screws supplied.
- Page 4 13. Plug the antenna lead and the vehicle harness 14. Reconnect the negative cable to the battery. connectors into the rear of the radio and the 15. Check the operation of the cassette player hazard switch. Slide the center panel into the according to the Owner’s Manual supplied.
Need help?
Do you have a question about the 08A03-5C2-050 and is the answer not in the manual?
Questions and answers