Alinco DJ-191 Instruction Manual page 16

III
• Charger EDe-63
(for 120VAC),
EDC-64
(for 22OVAC)
• Ni-Cd
Battery
EBP-33N/34N/35N/36N/37N
-
1 . The battery pack is not charged when shipped. It must be charged before using.
2. Charging should be conducted in the temperature range of O°C to 40°C, as incom-
plete charging or deterioration of battery performance may occur if charged outside
this range.
3. Do not modify, dismantle, incinerate or immerse the battery pack in water as this
may be dangerous. Be careful not to drop the battery pack or subject it to any severe
shocks.
rami
1. Turn off the transceiver power while charging.
2. Never charge the battery packs of other makes with this Charger.
3. The required charging time depends on the conditions and the models of battery
pack. Refer to the instruction manuals of the battery pack.
4. Never short-circuit the charging terminals of this Charger with a metal object, etc.
for the charger may be damaged by a strong current.
5. Precaution
Don't insert the above mentioned Ni-Cd batteries viceversa.
This mis-use causes damage on the drop in charger.
6. Never mount the battery pack in the charger backwards.
7. Charging should be conducted in the temperature range of O°C to 40°C as incom-
plete charging or deterioration of battery performance may occur if charged outside
this range.
Charging with EOe-60 or EOC-61 (QUick Charger)
1. Mount the Ni-Cd battery pack in the charger. The red lamp will light up and charging
will start.
2. When the battery pack is mounted correctly, the red lamp will light up and quick
charging will start.
When quick charging is completed, the red lamp will go off/the green lamp will light
up. The charge rate will be then reduced to a weak supplementary charge rate to
protect the battery pack from overcharging.
Charging with EOe-63 or EOe-64 (Normal Charger)
1. Mount the Ni-Cd battery pack in the charger. The red lamp will light up and charging
will start.
2. See table 2 for charging time. Dismount the battery pack from the charger after the
charging.
4. Never short-circuit the battery pack terminals, as this may cause damage to the
equipment or lead .to heating of the battery which may cause burns.
5. Unnecessarily prolonged charging (overcharging) may result in deterioration of
battery performance.
6. The battery pack should be stored in a dry place with a temperature range of - 20°C
to +45°C. Temperatures outside this range or extremely high levels of humidity
may lead to leaking of the battery liquid or resting of the metal components of the
batteries.
7. Normally the battery pack can be charged up to 300 times. However, the battery
pack can be considered to be exhausted if the period of use drops off markedly
despite being charged for the aforementioned time. When this happens, a new pack
should be used.
8.
~
ATIENTION: The battery that you have purchased is recyclable. At the
f6¢1
end of it's useful life, under various state and local laws, it may be illegal
Hi-Cd
to dispose of this battery into the municipal waste stream. Check with
your local solid waste officials for details in your area for recycling options
or proper disposal.
EBP-33N
EBP-34N
EBP-35N
~
EBP-36N
WEBP-37N
EDC-63I64
This unit is a Charger for exclusive use of Ni-Gd Battery
Packs used with the ALiNCO handheld transceiver.
With EDC-63/EDC-64, the battery packs EBP-33N/
EBP-34N can be charged while it is attached to the trans-
ceiver or the receiver.
<
Installation>
Insert the battery-pack fully into the charger unit, matching
the grooves. The red lamp will light up and charging will
start.
26
27