Related Manuals for PAC P1C-GM12
Summary of Contents for PAC P1C-GM12
- Page 1 INSTALLATION MANUAL VIDEO INTEGRATION MODULE This manual shows the install into a single applicable vehicle. Other vehicle disassembly will vary. wiring remains the same with all vehicles. See application guide for applicable vehicles...
- Page 3 INTERFACE DIP SWITCH SETTINGS DIP 1 A/V 1 ON A/V 1 OFF DIP 2 A/V 2 ON A/V 2 OFF DIP 3 A/V 3 ON A/V 3 OFF DIP 4 AFTERMARKET CAMERA OEM CAMERA DIP 5 4.2” SCREEN 8”SCREEN DIP 6 TOUCH SCREEN CALIBRATION ON TOUCH SCREEN CALIBRATION OFF ...
- Page 4 RADIO CONTROL PANEL...
- Page 5 RADIO CONTROL PANEL BUTTON FUNCTIONS HOME BUTTON FUNCTIONS ARE DETERMIDED BY THE “HOME” BUTTON SELECTED IN THE INTERFACE SETTINGS MENU. YOU CAN SELECT ANY BUTTON TO BE THE “HOME” BUTTON IN THE HOME BUTTON PROGRAMMING SECTION OF THE INTERFACE SETTINGS. WHEN PRESSED IN FACTORY BUTTON WHEN PRESSED IN NAV SCREEN...
- Page 6 REMOVE TRIM BEZEL AROUND RADIO. SET ASIDE. REMOVE FOUR 7MM SCREWS FROM THE CORNERS OF THE CONTROL PANEL. GENTLY PULL ON CONTROL PANEL TO RELEASE THE TWO CLIPS LOCATED ON THE SIDES. UNPLUG ALL PLUGS FROM CONTROL PANEL AND SET IT ASIDE.
- Page 7 PLUG SUPPLIED T-HARNESS (TWO) INTO THE CONNECTIONS ON THE BACK OF THE CONTROL PANEL. . T-HARNESSES PLUGGED IN. PLUG MOLEX CONNECTOR FROM T- HARNESS INTO THE MAIN HARNESS. ROUTE MAIN HARNESS TO DESIRED LOCATION OF INTERFACE BOX.
- Page 8 PLUG TWO CONNECTORS INTO INTERFACE. THE OTHER CONNECTORS SHOWN IN THIS PICTURE (3PIN & 2PIN) ARE FOR DVD IR AND ARE NOT NEEDED UNLESS INSTALLING AN AFTERMARKET DVD PLAYER NEEDING TOUCH CONTROL. PLUG LVDS T-HARNESS INTO LVDS SOCKET. THERE ARE GUIDES LOCATED ON PLUG TO ALIGN IT CORRECTLY.
- Page 9 ONCE IN THE NAVI MODE PRESS AND HOLD THE TOUCH SCREEN FOR ABOUT 8 SECONDS UNTIL THE INTERFACE MENU DISPLAYS. ONCE INSIDE THE MENU, CHOOSE THE HOME BUTTON LEARNING BY PRESSING START. ONCE THIS IS DONE, PRESS THE HOME BUTTON ON THE RADIO AGAIN TO LEARN THAT BUTTON FOR THE SWITCHING OF NAVIGATION, A/V1,2,3,...
Need help?
Do you have a question about the P1C-GM12 and is the answer not in the manual?
Questions and answers