Do you have a question about the FSGWBG1000 and is the answer not in the manual?
Questions and answers
Summary of Contents for Game Winner FSGWBG1000
Page 1
BRAND Assembly Instructions Hunter’s Grill Model #FSGWBG1000 Please keep this instruction manual for future reference Customer Service: (888) 837-1380, 8:00am to 5:00pm, Pacific Standard Time, Monday thru Friday (Made in China) SC2000314-GW-00– ENG 20131026-V1...
Warnings Please read Safety and Precaution statements, Grill Maintenance, Leak Testing, Regulator/ Cylinder connection and Lighting Instructions before using grill the first time. Safety Symbols The symbols and boxes shown below explain what each heading means. Read and follow all of the messages found throughout the manual. DANGER Danger: Indicates an imminently hazardous situation which, if not avoided, will result in serious injury or death.
Page 4
Warnings DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open Lid. 4. If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department. Failure to follow these instructions could result in fire or explosion which could cause property damage, personal injury or death.
Page 5
Warnings • The appliance shall not be used on or under any apartment or condominium balcony or deck. • The appliance shall be used outdoors only, and shall not be used in a building, garage or any other enclosed area. •...
Page 6
Warnings USE OF LP GAS CYLINDER AND INSTALLATION BEFORE INSTALLING: LP GAS CYLINDER • The installation must conform with local codes or, in the absence of local codes,with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, Storage and Handling of Liquefied Petroleum Gases, ANSI/NFPA 58;...
Page 7
Warnings CAUTION (a) Do not store a spare LP-gas cylinder under or near this appliance; (b) Never fill the cylinder beyond 80 percent full; and never refill 16.4 oz bottles. (c) If the instructions in “(a)” and “(b)” are not followed exactly, a fire causing death or serious injury may occur.
Page 8
Warnings TO TEST Make sure the control knobs are in the “OFF” position, and turn on the gas supply. Check all connections at the Gas cylinder, LP gas regulator and supply valve up to and including all connections to the pipe that go to the burners (the diagram shows the point where the soap water mixture is being applied).
Page 9
Warnings WARNING Natural Hazards -Insects and Spiders A clogged tube can lead to a fire beneath the appliance. During shipment or storage, it is possible that small Insects and spiders could find their way into the venturi tubes and make nests or webs.
Parts List Lid Handle Lid Handle Bracket 2pcs Grill Body Assembly 3a: Grill body with hose regulator assembly – 1 pc 3b: Grill lid – 1 pc 3c: Legs – 1 set 3d: Control knob – 2 pcs 3e: Lighting rod – 1 pc 3f: Lid lock –...
Page 12
Parts List Flame Tamer 2pcs Side Table Assembly 7a: Side Table – 1 pc 7b: Lock Assembly – 1 pc Wheel 2pcs Wheel Cover 2pcs 10 Oil Drip Tray Plastic Leg Base 2pcs SC2000304-OG-00– ENG P.12 20131026-V1...
Assembly Instructions SC2000304-OG-00– ENG P.14 20131026-V1...
Page 15
Assembly Instructions Step 1: Take out the Grill Body (3) from the packing box and keep the grill body in folded position. Loosen the screws on legs as following. Insert these screws through the center hole of the Plastic Leg Base(11) and tighten them firmly.
Page 16
Assembly Instructions Unfold the Grill as per following figure. Step 3A: Step 3B: SC2000304-OG-00– ENG P.16 20131026-V1...
Page 17
Assembly Instructions Step 4: Attach Side Table (7) to Grill Body by using 4 pcs of M6x15mm Bolt (#C) and M6 Washer (#D). #C & #D #C & #D #C–M6x15mm Bolt x 4 pcs #D – M6 Washer x 4 pcs SC2000304-OG-00–...
Page 18
Assembly Instructions Step 5: Insert M6x55mm Bolts (#E) through the Lid Handle Brackets (2) and Lid Handle (1). Tighten the the Handle firmly to the Lid. #E - M6x55mm Bolt x 2 pcs Step 6: Place the Flame Tamer (6) over the burners and use 4 pcs of Cotter Pins (#F) to maintain the Tamers in...
Page 19
Assembly Instructions Step 7: Place the Cooking Grates (4 and 5). 4 and 5 Step 8: Insert the Oil Drip Tray (10) under the Grill Body. Assembly is completed!!! Before Cooking for the First Time Operate grill 15 minutes with grill lid closed and gas control on HIGH. This will heat-clean internal components and eliminate odor of oil in grill.
Operating Instructions Unfold Grill Note: Unlock the latch before unfolding the legs Step 1: Step 2: SC2000304-OG-00– ENG P.20 20131026-V1...
Page 21
Operating Instructions Fold Grill Note: Side table should be completely folded before moving the grill LOCK the pin and latch before moving the grill. WARNING Propane Gas Cylinder MUST be detached from regulator before folding the grill DO NOT fold the grill or move the grill immediately after cooking. Wait for the grill to cool down completely! Remember!!! Detach gas cylinder before folding SC2000304-OG-00–...
Operating Instructions Fold / Unfold Side table Pull the latch Pull the latch Lighting Instructions 1. Read all instructions before lighting 2. Open lid during lighting 3. Make sure the propane gas cylinder is tightly threaded into the regulator (hand tighten only). 4.
Page 23
Operating Instructions Manually Lighting Your Grill By Match 1. Important! OPEN LID. Attempting to light burner with lid closed may cause an explosion. Do not expose any part of your body or clothing directly above cooking area when lighting. 2. Using the lighting rod with a match, ignite the match and insert through the cooking grates to the burners.
Page 24
Operating Instructions Turning grill off • After cooking, turn the grill off by rotating the control knob to OFF. Control knob should pop up in the OFF position. If control knob does not pop up, disconnect cylinder to turn grill off and replace the regulator.
Grill Maintenance Grill Maintenance • Clean and inspect pressure regulator and hose assembly prior to use. • Allow grill to cool before cleaning. Frequency of cleaning is determined by how often grill is used. • DO NOT use self-cleaning oven to clean any grill part. Extreme heat would remove any chrome plating and cause premature rusting.
Page 26
Grill Maintenance To reinstall the main burners: 1. Insert the burner over the main burner gas valve. 2. Make sure the orifice spud (A) is inside the burner venturi (B) 3. Align the burner screw hole with the firebox hole, insert screw and tighten.
Warranty Information Manufacturer warrants this Product to be free from defects in workmanship and materials for a period of 90 days from the date of purchase, PROVIDED claims are submitted, in writing, with proof of purchase. If any part of this item fails because of a manufacturing defect within the Limited Warranty Period, Manufacturer offers to replace such part(s) provide that such parts have not been improperly repaired, altered, or tampered with or subject to misuse, abuse or exposed to corrosive conditions.
Page 28
Warranty Information IF CUSTOMER SERVICE IS NECESSARY: The Original Purchaser is responsible for shipping and handling charges of the returned item(s) and replacement parts, if any. All parts to be replaced will need to be shipped before replacement items will be sent. Follow the Customer Service Representative’s instructions exactly.
Need help?
Do you have a question about the FSGWBG1000 and is the answer not in the manual?
Questions and answers