Summary of Contents for QSurround Cine magic
- Page 1 OWNER’S MANUAL MHSCB1-01 Cube Speaker System MHSFL1-01 In-Wall Speaker System MHSZ21-01 Zone 2 Kit agic Built-In Home Theater System QSurround is a trademark of QSound Labs, Inc.
-
Page 2: General Information
Amplifier” in this manual. The Amplifier is designed to enhance audio performance from audio / video components without requiring significant manual adjustments. The Amplifier utilizes QSound Lab’s sound processor, QSurround , to create dynamic surround sound from any stereo matrix encoded signal. The Amplifier incorporates internal switching mechanisms and sensors to automatically distribute sound to and from the appropriate location and source. -
Page 3: Parts Description
The Amplifier provides two types of connections from a stereo source: speaker level or line level. Only one of the two connections will be played through the Amplifier. The most common connection from a stereo source is speaker level. See diagrams above for connections. QSurround is a trademark of QSound Labs, Inc. -
Page 4: Customizing Sound Fields
Amplifier. See illustration below: Video Component A television can be connected to the Zone 2 Amplifier through an audio cable. See illustration below: Customizing Sound Fields QSurround is a trademark of QSound Labs, Inc. - Page 5 Allows you to listen to stereo source while watching television. If television is muted, stereo will play after a 15 second delay. Volume Control: Main listening area volume is controlled through audio / video component connected to the Amplifier. QSurround is a trademark of QSound Labs, Inc.
- Page 6 A television signal connected to the Zone 2 Amplifier will override the signal received from the Amplifier. Once the television signal is terminated, the audio signal from the Amplifier will play after a 15 second delay. QSurround is a trademark of QSound Labs, Inc.
-
Page 7: Specifications
8 ohm Sensitivity (1W/1M) 89 db 89 db 89 db 89 db 89 db Frequency Response 60Hz-20kHz 60Hz-20kHz 125Hz-20kHz 45Hz-2.5kHz 250Hz-20kHz Weight 3.5 lbs 2.6 lbs 2.2 lbs 3.7 lbs 1.4 lbs QSurround is a trademark of QSound Labs, Inc. - Page 8 Amplifier must be mounted so that the heat sinks are in a vertical position. • Do not place the amplifier near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. QSurround is a trademark of QSound Labs, Inc.
-
Page 9: Limited Warranty
For your convenience, River Park, Inc. has established a telephone number for frequently asked questions: River Park, Inc. 1-800-442-7717 or write to: River Park, Inc. Technical Support 21953 Protecta Drive Elkhart, Indiana 46516 QSurround is a trademark of QSound Labs, Inc. -
Page 10: Installation
3. Place speaker into hole cut out. 4. Screw down until mounting bracket tightens to wall board. 5. Place adhesive in speaker bevel 6. Fasten grill. Cube 1. Connect speaker wire. 2. Screw mounting bracket to wall board. QSurround is a trademark of QSound Labs, Inc. -
Page 11: Placement Of Speakers
15 feet apart from each other. A reference is to place the speakers so that they form a 45 degree angle to the listening area. 3. The speakers should be in line with the television monitor or just above the television monitor. QSurround is a trademark of QSound Labs, Inc. - Page 12 The cube speakers are identical and are used as the Center, Front Left and Right, Surround Left and Right. Follow same placement recommendations for In-Wall speakers. The Subwoofer placement is identical to the In-Wall speakers. QSurround is a trademark of QSound Labs, Inc.