Advertisement
Step 3
• Set the power switch to on (I) and the sewing speed
controller to maximum.
Place a spool of thread on the spool pin, with the
thread coming from the bottom (
• Choose a spool cap slightly larger than the spool, and
push it firmly onto the spool pin to hold the spool.
If you are using a fine thread, then pull the spool cap
back slightly so that there is a slight gap (
• Unwind some thread and pass the thread under the
thread guide (
figure 3c
• Loop the thread behind and over the hook then
clockwise around the disk (
• Clip a bobbin onto the bobbin winding shaft
(
figure 3e
) .
Push the bobbin winding shaft firmly to the right until
it clicks into place against the stop.
Wind the thread clockwise around the bobbin four or
five times, then pass the thread down through the slit
and pull to the right to trim the thread on the cutter.
• Using the start/stop button or the foot controller:
start the machine, and continue winding until the
winding shaft stops automatically.
Push the bobbin winding shaft back to the left, cut the
thread (
figure 3f
), and remove the bobbin from the shaft.
Unwind the thread from the disk.
Step 4
• Open the bobbin cover by sliding the latch to the
right (
).
figure 4a
• Leaving about 15cm (6in) of thread trailing, insert the
bobbin into the shuttle with the thread direction anti-
clockwise as shown in
Carefully guide the thread around the channel as
shown, then pull towards you to trim the thread on the
cutter.
• Close the bobbin cover as follows:
Insert the tab into the slot (
Push down on the right side until the cover clicks shut
(
).
figure 4d
Winding the bobbin. (Your machine may be supplied with a fully wound
bobbin, but you may want to fill another bobbin with your own thread.)
figure 3a
).
figure 3b
).
).
figure 3d
Setting the bobbin. (Your machine may be supplied with a bobbin already
fitted, but you may want to use another bobbin with your own thread.)
.
figure 4b
).
figure 4c
figure 3a
spool cap
figure 3c
thread guide
).
figure 3d
disk
hook
figure 3e
cutter
figure 4a
figure 4c
figure 3b
gap
figure 3f
figure 4b
cutter
figure 4d
Hide quick links:
Advertisement
