Advertisement
Training the phone command
The training is a two step process. First you train the command words that will turn the phone on and off.
Then you program the dialer for the names and numbers you want to dial.
If you have trouble with the dialer names, or speech, triggering the phone, try changing the name to dial
you have programmed or change the command words.
Note: the phone requires that two names must be programmed for the control command. The phone will
'look' for the first word and will then 'look' for the second word to be said within 3 seconds. If not, it will go
back to listening for a command. This is done to help reduce 'Falsing'.
Phone command training steps:
Place the status switch in the pgm position.
Push the train word switch
The status led will be yellow or turn yellow.
Say the first word (we recommend 'activate'. The yellow led will go off and back on. Say the word again.
The led will go off and come back green if the word matched the first entry. If it comes back yellow that
means the second training did not match the first. Say the word again until the led turns green.
Once the led has turned green, say your second command word (we recommend 'telephone' the green
led will go off and back on. Say the second word as many times as necessary until the led will alternately
blink yellow and green, indicating that the second word has been matched.
The led will then turn steady green indicating that the two command words have been stored
successfully. The phone is now ready for voice command and to have the names to dial to be
programmed.
Switch the pgm / oper switch to oper and you are in control of the phone and ready to continue to the
programming of the dialer.
When you say the first word the green led will turn yellow. Say the second word within 3 seconds and the
red led will blink on and off indicating the second word has been recognized and the phone will be
commanded.
Advertisement
