Maintenance Table On The Monitor Screen - Sanyo TLS-1960P Service Manual

MAINTENANCE TABLE ON THE MONITOR SCREEN

To display the maintenance table, press "MENU" key with "
POWER FAILURE
Normal screen
Maintenance table 1
The used time of each mode (part) is displayed, and can be
reset by items.
Access the maintenance-screen according to the above,
and then Fig. below is displayed.
Move the blinking to the item to be reset with JOG dial and
press the "MENU RESET" key, and then the used time for the
item will be reset.
MAINTENANCE TABLE 1
< USED TIME / ALARM >
VIDEO
POWER
ALARM
VIDEO: Used time of the video head (cylinder) total
hours.
Note : Reset when the cylinder is replaced.
POWER: Hours of the power supply being.
ALARM: Number of ALARM REC.
Note: The data for the maintenance tables are memoried
2
in E PROM, and the memory can be kept if the timer
microcomputer is reset.
Press "MENU" key with "
"MENU" key
0 0 0 0 0 H
0 0 0 0 0 H
0 0 0 0 0 0
" key while the fourth MENU <POWER FAILURE> is displayed.
" key
Maintenance table 2
Maintenance table 2
As shown in Fig. below Maintenance Table 2, <ERROR> is
displayed on the screen.
MAINTENANCE TABLE 2
<ERROR>
1 31 - 12 - 02
2 - - - - - - - -
3 - - - - - - - -
4 - - - - - - - -
5 - - - - - - - -
6 - - - - - - - -
7 - - - - - - - -
8 - - - - - - - -
When the "MENU RESET" key is pressed during display and
resetting all data.
<ERROR> : The newest data is displayed in the first line, and
the old ones are moved down one by one. Not-
displayed old data is cleared automatically.
– 3 –
Maintenance table 1
"MENU" key
E01 08
- - - - -
- - - - -
- - - - -
- - - - -
- - - - -
- - - - -
- - - - -