Elsema PCKeypad User Manual

Wireless keypad

Advertisement

Quick Links

User Manual

PCKeypad
Wireless Keypad

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PCKeypad and is the answer not in the manual?

Questions and answers

Summary of Contents for Elsema PCKeypad

  • Page 1: User Manual

    User Manual PCKeypad Wireless Keypad...
  • Page 2 The PCKeypad is a wireless keypad with a PentaCode® transmitter built-in. It works with all of Elsema’s PCR series receivers. The installer has the option to use the classic 12-way dip switch coding or one of over 17 billion encrypted codes.
  • Page 3: Installation

    Installation • Remove the back cover from the keypad using the supplied security screwdriver • Code the transmitter to the receiver prior to mounting the Keypad • Drill 4 holes on the wall for the screws and 1 hole for the cable •...
  • Page 4: Anti-Tamper Alarm

    Anti-Tamper Alarm The PCKeypad uses a built-in LDR (light dependent resistor) as an anti-tamper alarm. If the keypad is removed from the cover then the internal buzzer starts beeping for 1 minute. Reset to the Factory Default To reset the Keypad to the factory default follow the steps below:...
  • Page 5: Programming Guide

    Programming Guide * → Master code → # Enter Programming Mode (One beep, green light flashes 888888 is the factory default master code once, red light “On” to confirm After 1min with no button pressed keypad will exit programming mode    you are in programming mode.) * Exit is confirmed with flashing red light. ...
  • Page 6: Keypad Lockout

    Sound and Light Settings Light and Sound Setting   (Note: The below changes can only be done while in programming mode.) 7 → 4 → # To disable keypad backlight To set keypad backlight  7 → 5 → # To enable keypad backlight (Factory default) Press * to Exit. ...
  • Page 7 Programming to PentaCode® Receiver The PCKeypad will work with all of Elsema’s PentaCode® series receivers. There are 2 methods of programming the Keypad to the receiver. 12- Way Dip Switch Coding 1. Remove the back cover of the keypad using the supplied screwdriver.
  • Page 8 Keep this document in a secure and safe place. User ID Name of User Number Use Microsoft Excel to create a longer list. 2000 User ID numbers can be added. Visit www.elsema.com to see our full range of Gate and Door Automation Products...

Table of Contents