Download Print this page

Aquavision AVF17W-4FK Installation Manual

Table of Contents

Download this manual

Assembly Schematic

Fig 1.

The specifications shown were accurate at time of going to press. AQUAVISION

pictures simulated. All names and trademarks acknowledged. E. & O.E.

AQUAVISION'S S S S

AQUAVISION

policy of continuous development means some changes may take place. Please check with the office for confirmation. All screen

WWW.AQUAVISION.CO.UK

Tel: +44 (0)1992 708333

Fig 2.

REV 4.0.1

Table of Contents

Do you have a question about the AVF17W-4FK and is the answer not in the manual?

Page 1 Assembly Schematic Fig 1. Fig 2. ® The specifications shown were accurate at time of going to press. AQUAVISION AQUAVISION AQUAVISION AQUAVISION’S S S S policy of continuous development means some changes may take place. Please check with the office for confirmation. All screen REV 4.0.1...
Page 2 ® Run the cables to their positions as shown in Fig. 1, ensuring that there is enough cable slack to connect to the rear of the AQUAVISION unit. Ensure that the cables are easily available and cannot fall back into the cavity, etc.
Page 3 48 hours for the silicon to dry before use. You should regularly check the soundness of this joint and rectify as necessary. It is the responsibility of the installer/customer to make sure that the AQUAVISION® unit is installed and sealed correctly; your guarantee will be void if any problems are caused through installation faults or poor sealing.
Page 4 ® If necessary clean the front of the screen thoroughly. When cleaning the AQUAVISION LCD, never use an abrasive cleaner. The front of the screen has a soft plastic finish and therefore should be cleaned with a soft damp cloth and a mild, non-abrasive glass cleaning agent.

Avf24w-4fk