argon audio EZY-STAMP User Manual

EZY-STAMP
HAND HELD PNUEMATIC MARKING TOOL
ARGON TOOL's EZY-STAMP
Hand Held Pneumatic Marking Tool
Makes inspection marking quick and easy.
Used for recertification of DOT cylinders.
Stamp holder accommodates one standard
hand stamp at a time. The tools hammer blow
is controlled by air line pressure. Recommended
operating air pressure is 20-90 PSI.
USE OF THE TOOL REQUIRES BOTH HANDS. One to locate and hold the hand stamp
against the part to be marked, and one to hold and push the EZY-STAMP firmly against
Hand stamps slide into the socket and must be held
in place during the marking process. See proper
marking technique in photo to the right
EZY-STAMP-250 Kit, I
character hand stamp numbers #0 thru 9 and the letter "E".
This tool is normally used for recertification of DOT
cylinders. Optional 1/8", 5/32", and 3/16" stamps available
upon request. Call for pricing.
EZY-STAMP-375 Kit
I
ncludes one (1) set of 3/8" character hand stamp numbers
#0 thru 9 only.
32309 Milton Avenue, Madison Heights, Mi 48071,1-800-466-4664,
Telephone 248-583-1605, Fax-248-588-0051, e-mail sales@argontool.com
ncludes one (1) set of 1/4"
ARGON TOOL, INCORPORATED
Tool weights
approximately
4 pounds
the stamp while actuating the trigger.
When the trigger is pulled, a series of
hammer blows "Burp" will create the
mark. A one second "Burp" is all that
is required. The stamp face may be
inserted back into its indentation and a
second "Burp" of the tool can create a
deeper impression if desired.
Made In The
U.S.A.