Sharp AR-5012 Service Manual page 60

Main Sub
code code
26 64 Heater control setup during the scanner mode
When this simulation is executed, the currently set code number of heater control setup is displayed. Enter a desired code number of
heater control setup and press the PRINT switch, and the new setup is enabled.
Code number
0
1
30 01 Paper sensor status display
Indicates the paper sensor status using the lamps on the operation panel.
Before-resist paper sensor (PPD1)
Fusing section paper sensor (PPD2)
Paper exit sensor (POD)
2nd CS paper sensor (PPD3)
New drum cartridge sensor (PUIS)
Single manual feed paper sensor (MFD)
43 01 Fusing temperature setup (Normal copy)
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed.
Code number
0
1
2
3
4
5
04 Fusing temperature setup 2
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed.
Code number
0
1
2
3
4
5
05 Fusing temperature setup in duplex copy
In duplex copy, this setup value is added to the fusing temperature of single copy. When this simulation is executed, the current setup
of the code number is displayed. Enter the code number and press the PRINT switch to enable the setup.
Code number
0
1
2
3
4
5
6
7
8
9
09 Setup of fusing control of postcard size paper
Code number
0
1
The default for Japan model is "1."
Heater control setup
Heater control ON * Default (Except for Europe)
Heater control OFF * Default (For Europe only)
Sensor name
Developer cartridge replacement lamp
JAM lamp
Photoconductor cartridge replacement lamp
2nd cassette lamp
Zoom lamp
AE lamp
Set temperature (° C)
175
180
185
190
195 (* Default)
200
Set temperature (° C)
155
160
165
170 (* Default)
175
180
Temperature shift (° C)
±0° C * Default
– 8° C
– 6° C
– 4° C
– 2° C
±0° C
+2° C
+4° C
+6° C
+8° C
Setup
Cancel * Default
Setup
AR-5012 SIMULATION, TROUBLE CODES 10 - 8
Content
Display lamp