Wineandbarrels Vinobox,C50 1T Instruction Manual page 5

Vinobox ,C 50 2T
 The controls of your wine Cooler
RUN
•
Indicator light illuminates to signify the cooling mode is currently in operation.
Light
•
To control the inner light turn on/off.
Power
•
To control this appliance turn on/off.
"Set Upper" Button
•
To set the temperature of the upper chamber.
"Set Lower" Button
•
To set the temperature of the lower chamber.
"Up chamber"
•
To shows the temperature of the up chamber.
"Lower chamber"
•
To shows the temperature of the lower chamber.
 Setting the Temperature Control
Each cooling compartment of the wine cooler (upper & lower) is independently
•
controlled. To set the temperature:
Connect the power cord to a properly grounded outlet. In the event of a power interruption,
all previous temperature settings are automatically erased and each compartment will
default to a preset temperature setting of: 6
compartment.
Set the desired cooling temperature by pressing the buttons adjacent to the "set
•
upper/set lower" program. Each depression of the buttons will scroll through the
available temperature settings (for each compartment) in increments of 1 degree. The
temperature selected will flash in the LED display for approximately 5 seconds, then
revert back to display the temperature of the internal cabinet
Upper compartment: The temperature setting can be adjusted from 5
Lower compartment: The temperature setting can be adjusted from 10
To view the "set" temperature. (anytime) press and hold the corresponding button for
•
approximately 5 seconds, the "set" temperature will temporarily "flash" in the LED display
for 5 seconds.
 Note
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before
•
restarting the unit. If you attempt to restart before this time delay, the Wine Cooler will
not start.
When you use the wine cooler for the first time or restart the wine cooler after having
•
been shut off for a long time, there could be a few degrees variance between the
temperature you select and the one indicated on the LED readout. This is normal and it
is due to the length of the activation time. Once the wine cooler is running for a few
hours everything will be back to normal.
for upper compartment and 12
5
for lower
to 10 .
to 18 .