EzwatchPro SKU# IR CAMERA WATERPROOF BULLET B/W CAMERA 8 INFRARED LED's User Manual

Advertisement

DIGITAL VIDEO CAMERA
User's Manual
SKU# IRCAMERA
SKU# IRCAMERA
WATERPROOF BULLET B/W CAMERA
8 INFRARED LED's
WARNING
WARNING

Attention:

To reduce the danger of electric shock, please do not open the case (or back
cover) of camera; everything needed for user operation is on the surface of
the camera; please seek help from a qualified professional for repair.
the camera; please seek help from a qualified professional for repair.

Attention items:

• Do not touch CCD or lens
• Do not use any unidentified power supply
• Avoid installation in unstable places
• Avoid installation in unstable places
• Do not use camera in the following conditions,
Temperature: -20⁰C/+50⁰C
FRONT VIEW
SIDE VIEW
• Suggested mounting height 8'-12'
• Do not mount camera directly to a metal surface
• Do not point camera directly into light sources
• Do not point camera directly into light sources
Image Sensor
Image Sensor
Effective Pixels
PAL:500(H)x582(V) NTSC:510(H)x492(V)
Sensor area
Signal system
Horizontal resolution
Minimum illumination
Electronic shutter
Electronic shutter
Auto:1/50(1/60)-1/100,000Sec
Auto:1/50(1/60)-1/100,000Sec
S/N ratio
Gamma
Lens
Video output
IR wave length
Power supply
Power supply
Power consumption
IR distance
REAR VIEW
1/3" CCD
1/3" CCD
4.9mmx3.7mm
PAL/NTSC
420TVL
0Lux(IR LED ON)
>48dB
0.45
3.6mm
1.0Vp-p, 75Ω
850nm
DV 12V±10%
DV 12V±10%
less than 3.0W
25-30M

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SKU# IR CAMERA WATERPROOF BULLET B/W CAMERA 8 INFRARED LED's and is the answer not in the manual?

Questions and answers

Summary of Contents for EzwatchPro SKU# IR CAMERA WATERPROOF BULLET B/W CAMERA 8 INFRARED LED's

  • Page 1 FRONT VIEW SIDE VIEW REAR VIEW DIGITAL VIDEO CAMERA User's Manual SKU# IRCAMERA SKU# IRCAMERA WATERPROOF BULLET B/W CAMERA 8 INFRARED LED's • Suggested mounting height 8'-12' • Do not mount camera directly to a metal surface • Do not point camera directly into light sources •...
  • Page 2 Installing a power wire pigtail Contact Step 1: At the camera location, take the power EZWATCHPRO cable and strip away the outer sheathing to expose the inner two wires (black & red). Then www.ezwatch-security-cameras.com strip away about 1/4"...

Table of Contents