Advertisement
SPECIFICATIONS
Input Impedance
INPUT:
Gain Range
GAIN:
Gain Peak LED
Frequency Response
CHARACTER:
Filter:
Gain:
COMP/LIMIT:
Compressor Gain
Attenuation
Compression Ratio
Attack (80%)
Release (80%)
Bass Filter:
FILTER SECTION:
Middle Filter:
Treble Filter:
Bright:
Output Level
BALANCED OUTPUT:
Frequency Response
XLR Connections
Options
EFFECT LOOP:
Loop Signal Level
Gain
Output Impedance
Input Impedance
Output Impedance
LINE OUT:
Signal Level
Impedance
PHONES OUT:
POWER AMP:
Continuous Output Power
Protection
AUXILIARY INFO:
Power Requirements
Mains Protection:
Dimensions (WxDxH)
Weight:
Specifications are subject to change without notice!
EBS REIDMAR
250 W BASS HEAD
D
D
ESIGNED AND
*
G
RINDSTUVÄGEN
(
+46 8 735 00 10, F
E-
MAIL
www.ebssweden.com
WEB:
2 Mohms // 100 pF
min/max
-oo/ +30 dB
+10 dBv
+0 / -3 dB
20 - 20.000 Hz
Type
Shelving High/Low Pass
Lo
+7 dB @ 40 Hz
Mid
-2 dB @ 800 Hz
Hi
+3 dB @ 10 kHz
0 dB
max
24 dB
max
3:1
typ
<10 ms
typ
100 ms
Type
12 dB/oct. Shelving
Gain Range
+/- 18 dB @ 60 Hz
Type
Bandpass Filter
Frequency Range
100 - 6.000 Hz
Q - Boost
0.7 - 1.1
Q - Cut
0.8 - >10
Gain Range
+/- 12-15 dB
Type
Shelving
Gain Range
+/- 18 dB @ 6 kHz
Type
Shelving
Gain Range
+15/-0 dB @ 10 kHz
Nominal
-10dBv
+0/-3 dB
10 - 20k Hz
1-GND, 2-Hot, 3-Cold
GND Lift, Pre/Post EQ
nominal
-10 dBv
Unity (1:1)
100 ohms
>50 kohms // 100
100 ohms
nominal
0 dBv
recommended
32 - 200 ohms
@4 ohms
250 W RMS
@8 ohms
125 W RMS
Short circuit,
High temperature
max
400 W
T2A Fuse (230V)
T4A Fuse (100/120V)
max
36 cm x 25 cm x 7.5 cm
14" x 9.8" x 3.0"
3.2 kg ( 7.1 lbs.)
EBS S
AB
EVELOPED BY
WEDEN
44-46, SE-16733 B
, S
ROMMA
WEDEN
: +46 8 735 00 05
AX
ebs.info@bass.se
:
REIDMAR
Contents:
August 2011
Users Manual
250 W BASS HEAD
Page:
2
3
Specifications
4
Page:
6
8
Advertisement
Table of Contents
Summary of Contents for EBS REIDMAR
- Page 1 Block Diagram Specifications 14” x 9.8” x 3.0” Front Panel Controls Weight: 3.2 kg ( 7.1 lbs.) Specifications are subject to change without notice! EBS REIDMAR 250 W BASS HEAD EBS S ESIGNED AND EVELOPED BY WEDEN 44-46, SE-16733 B RINDSTUVÄGEN...
- Page 2 9. The filters are basically of the boost/cut SPEAKER OUTPUT – Connect your The EBS Reidmar handles a 4 Ohm load and is the design. This means that the level controls speakers here. Care should be taken when perfect companion to a stack of Mini size ClassicLine...
- Page 3 FRONT PANEL CONTROLS BLOCK DIAGRAM Bright Bass + Treble VOLUME - The VOLUME knob controls all PILOT LAMP - Indicates power on condition. volume in the unit, controlling the poweramp and LINE output. The balanced output (XLR) is not affected by the setting of this knob.
- Page 4 - Control to adjust the instruments' signal INPUT - A low noise, high impedance FILTERS - The filter section contains four strength to the right operating level in the EBS instrument input that will interface with passive Midrange enhanced performance filters: Reidmar.
Need help?
Do you have a question about the REIDMAR and is the answer not in the manual?
Questions and answers