Summary of Contents for Deklin Technologies AIU-900A
-
Page 1: Installation Manual
AIU-900 Autopilot Interface Unit Installation Manual Rev 1.11 July 15, 2012 Deklin Technologies Inc 413 Childe Harolds Lane Brentwood, TN 37027 Tel: (615) 819-0800 Fax: (615) 819-0801 www.deklintech.com... - Page 2 REVISIONS DESCRIPTION DATE APPROVAL Initial Release March 5, 2011 Certification requirements, April 15, 2011 parts list update, schematic dwg update 1.11 Address Change July 15, 2012...
-
Page 3: Table Of Contents
Operational Checkout _____________________________________________ 3 Section IV – Warranty and Service_____________________________ 4 WARRANTY __________________________________________________________ 4 FACTORY SERVICE ____________________________________________________ 4 Appendix A - Schematic _____________________________________ 5 Appendix B - Interconnects __________________________________ 6 Appendix C - Mechanical ___________________________________ 16 Deklin Technologies, Inc. 2011... -
Page 4: Section I General Information
This manual provides detailed installation instructions for the AIU-900 series Autopilot Interface Unit. EQUIPMENT DESCRIPTION The Deklin Technologies, Inc. AIU-900 series are a pre-assembled autopilot interface unit following the interconnect specifications and component requirements recommended by the manufacturers of certain PFD systems when interfaced with existing 1C388 series autopilot couplers. -
Page 5: Specifications
25 Pin Female D-Sub Connector Mounting: Bulkhead, Four 8/32 Screws Input Specifications Input Voltage: Not Applicable Current: Not Applicable Component List AIU-900A Capacitors: 0.027uF, 0.047uF Metalized Polyester, 100V Inductor, Choke: 18 mH, 27mH Resistors: 10.0 kOhm, 100.0 kOhm 0.25W, 1% Trim Pots:... -
Page 6: Section Ii - Installation
Section I. If any claim is to be made, save the shipping material and contact the freight carrier. DO NOT return any items damaged in shipping to Deklin Technologies, Inc. If any items show signs of external shipping damage, contact Deklin Technologies, Inc for a replacement. Do not attempt to install a damaged unit. -
Page 7: Noise
Post Installation Check After installation wiring is complete, verify no power is on any pin and airframe ground on pin 5 only. Operational Checkout Follow instructions in specific OEM PFD Installation Manuals for check out procedures. Deklin Technologies, Inc. 2011... -
Page 8: Section Iv - Warranty And Service
ICAO agency). If during the warranty period this unit should fail it will be at the discretion of Deklin Technologies, Inc to send a replacement unit or repair the original unit. All units must be returned to the factory for repair or replacement. -
Page 9: Appendix A - Schematic
Appendix A - Schematic Deklin Technologies, Inc. 2011... -
Page 10: Appendix B - Interconnects
Appendix B - Interconnects Deklin Technologies, Inc. 2011... - Page 11 Deklin Technologies, Inc. 2011...
- Page 12 Deklin Technologies, Inc. 2011...
- Page 13 Deklin Technologies, Inc. 2011...
- Page 14 Deklin Technologies, Inc. 2011...
- Page 15 Deklin Technologies, Inc. 2011...
- Page 16 Deklin Technologies, Inc. 2011...
- Page 17 Deklin Technologies, Inc. 2011...
- Page 18 Deklin Technologies, Inc. 2011...
- Page 19 Deklin Technologies, Inc. 2011...
-
Page 20: Appendix C - Mechanical
Appendix C - Mechanical Deklin Technologies, Inc. 2011...
Need help?
Do you have a question about the AIU-900A and is the answer not in the manual?
Questions and answers