Advertisement
Specifications & Capacities
Riding Mowers
Starter
Charging System
Governor
Fuel
Fuel Capacities
Ground Speed
Steering Type
Twin Lever Steering Controls
Steering Turning Radius
Brake Service
Park Brakes
Mower Drive
Safety Features
Seat
Mainframe Construction
Drive Motor Mount
Front Caster Wheels
Front Caster Forks
Deck Thickness
Reinforced Deck Front
Deck Trim Edges
Deck Housing Depth
Deck Lift
Hand Operated Controls
Indicators
Cup Holder
Cutting Heights
Mowing Blades
Blade Tip Speed
Blade Drive
Spindles
Flotation
Designs, specifications, features and information are subject to change without notice.
2/22/08
General Specifications
Z44
12-volt (.8 KW), solenoid shift positive engagement. w/Honda Engine
12-volt (.8 KW), industrial Starter w/Briggs & Stratton Engine
12-volt, 20 amp w/Honda Engine
12-volt, 16 amp w/Briggs & Stratton Engine
Unleaded gasoline with octane rating of 87 or higher
Twin lever steering provides independent control of each drive wheel.
Speed, forward, reverse, brake, turns and park.
True zero degree. Turns with counter-rotating independent drive wheels
Spring applied electric release pawl over cog wheel.
Operator presence system connected to deck and drive clutches.
Molded-vinyl seat. Bolt loosening required for forward and reverse adjustments.
Optional armrests kit for standard molded-vinyl seat.
Optional deluxe cushion seat with arm rests.
Mounted with roller bearings on each wheel.
11 Gauge decks with reinforcements welded into spindle mount areas
11 GA. x 3 1/2" x 1 1/2" Box-Section
Solid 1" x 3/8" steel bars for reinforced impact area
4 1/8" deep, (room for high-capacity mowing)
Foot-operated deck height adjustment.
Pin for setting height and transport position.
Ignition switch, throttle lever, control levers, blade engagement switch,
choke lever and Left/Right Fuel Tank Valve.
Engine warning light and hour meter
Two cup holders molded into the left side fuel tank.
Accommodates nearly any cup size including Big Gulp.
Foot-operated deck height adjustment. Pin for setting height, transport position. Height
adjustment in 1/4" increments from 1 1/2" to 4 1/2"
Heavy-duty, heat-treated, high-lift steel blades
.20" x 2 1/2" x 15.81"
16,811 FPM
V-belt drive to all three spindles. Spring tension idler pulleys.
Machine ductile housing, 1" diameter high carbon steel shafts
Free-floating mower deck using three blades with center blade to the front.
Mower deck is suspended at the four corners on spring-assisted chains.
Includes 4 anti-scalp wheels to improve flotation in rolling and uneven terrain.
Mechanical
12 US GAL
Forward: 0-7.5 MPH
Reverse: 0-5.5 MPH
Hydrostatic dynamic braking
Single V-belt with electric clutch
1 1/2" square solid steel.
1/8" welded steel
3/8" steel.
and greasable ball bearings.
Z52
.20 x 2 1/2" x 17.81"
18,937 FPM
357-187S end
62
Advertisement
