Advertisement
Quick Links
Attention: Read and understand these instructions before installing fixture. This fixture is intended for
installation in accordance with National Electric Code and local regulation: To assure full compliance with
local codes and regulations, check with your local electrical inspector before installation. This equipment
is guaranteed only when used as indicated in these instructions; Therefore they should be kept for future
reference. To prevent electrical shock, turn off power supply before carrying out any connection or
maintenance operations.
STEP 1
Make sure you have all the elements of the fixture
Your box should contain the following parts
STEP 2
Disasemble the fixture
1. Remove the two diffusers
2.1
2.1
Artemide inc.
1980, New Highway, Farmingdale (NY) 11735
T. +1 631 694 9292 | infousa@artemide.net | www.artemide.net
WALL/CEILING
Universal plate
ø5" J-Box Mounting plate
BLISS 13
Complete Bliss
assembled to be mounted
2. Loosen nuts on the threaded pins
3. Remove the front plate
T. +1 514 323 6537 | infocanada@artemide.net | www.artemide.net
Assembly instructions
2.2
2.3
11105, rue Renaude Lapointe, Montréal (QC) H1J 2T4
rev 0.1
Artemide Ltd.
1
Advertisement
Summary of Contents for Rezek BLISS 13
- Page 1 BLISS 13 Assembly instructions WALL/CEILING rev 0.1 Attention: Read and understand these instructions before installing fixture. This fixture is intended for installation in accordance with National Electric Code and local regulation: To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. This equipment is guaranteed only when used as indicated in these instructions;...
- Page 2 BLISS 13 Assembly instructions WALL/CEILING rev 0.1 STEP 3 Fix the fixture to the wall/ceiling 1. Fix the universal plate to the J-Box 2. Remove the back plate from the fixture by unscrewing (Screws not supplied) the two screws STEP 4 Install the fixture 3.
- Page 3 BLISS 13 Assembly instructions WALL/CEILING rev 0.1 STEP 5 Reinstall the complete fixture 1. Reinstall the front plate by slipping the 3. Reinstall the 2 diffusers by snapping the ridge on the plastic threaded pins into the slots in the bracket...