Advertisement
OPERATION
1. Plug the unit into the power supply. See Above.
2. Turn power switch on. The top and bottom element can be operated independently of each other.
3. Set thermostat to desired temperature to preheat. Note: A preheat temperature of 500 degrees
Fahrenheit will take approximately 15 minutes to reach. A preheat temperature of 600 degrees
Fahrenheit will take approximately 30 minutes to reach.
4. Adjust the thermostat to the desired temperature. The red light will cycle with the thermostats operation
of the heating elements.
5. The bell timer is manual and will ring once when it shuts off. Note: dial must be turned past 10 before
setting time.
6. After use, turn thermostat knob to off position.
7. To disconnect appliance, turn controls to off and remove plug from outlet.
WARNING: DURING NORMAL OPERATION, THE EXTERIOR OF THE UNIT IS HOT.
CLEANING
NOTE: Proper maintenance plays an important part in the life span and functioning of the unit.
1. Turn the temperature control to the OFF position. Unplug the power cord.
2. Allow the unit to cool 30 minutes.
3. Clean excess food debris from the interior of the unit.
4. The racks and crumb pan are removable and can be washed separately in the sink.
5. Clean exterior of unit with a stainless steel cleaner.
6. WARNING: DO NOT immerse in water or other liquid. DO NOT clean with water.
SERVICE INSTRUCTIONS
If the unit fails to operate properly, call NEMCO customer service toll free at 1-800-782-6761.
NEMCO FOOD EQUIPMENT
1-800-782-6761 T
301 Meuse Argonne, Hicksville, OH 43526
419-542-6690
oll Free
www.nemcofoodequip.com
2
Fax
45898
3/20/07
Advertisement
