Advertisement
Quick Links
Longix LE-T1000 Telephone Entry Controller
Installation Guide
This installation guide provides basic installation information, drawings, and controller setup instructions to use when
installing the Longix LE-T1000 Telephone Entry controller. The Longix LE-T1000 controller may be used alone or may
be connected to an access control network using LA-SYS family controllers. For instructions on how to install a postal
lock, see the Longix LE-T1000PL Postal Lock Installation Application Note.
NOTE: It is the responsibility of the installation organization to have only technically qualified personnel performing the
installation.
Section 1 - Drawings
Section 2 - RS-232 Serial Port
Section 3 - Setup Controller
Section 4 - Contact Longix Technologies Inc.
1.0
Drawings
Figure 1: The Longix LE-T1000 Telephone Entry Enclosure
Page 1 of 6
www.longix.com
Advertisement
Related Manuals for Longix LE-T1000
Summary of Contents for Longix LE-T1000
-
Page 1: Installation Guide
This installation guide provides basic installation information, drawings, and controller setup instructions to use when installing the Longix LE-T1000 Telephone Entry controller. The Longix LE-T1000 controller may be used alone or may be connected to an access control network using LA-SYS family controllers. For instructions on how to install a postal lock, see the Longix LE-T1000PL Postal Lock Installation Application Note. - Page 2 NOTE: You must power down the unit before attempting to make or remove any connections. Failure to do so will damage the controller. NOTE: You must set Jumper 11 if you intend to use the Longix controller’s internal modem. Page 2 of 6...
-
Page 3: Rs-232 Serial Port
Longix LE-T1000 Telephone Entry Controller Installation Guide RS-232 Serial Port An RS-232 serial connection between the Longix unit and the host computer can be done one of two ways: • by a direct serial connection (50 feet maximum) • through an external modem Direct Serial Connection The Longix Technologies Inc. -
Page 4: Setup Controller
The address range is from 1 to 128. The Master Controller must be set to address 1. Other slave Longix LA-SYS controllers may be assigned any number from 2 to 128. If the network is made up of LA-SYSs, the Longix LE-T1000 must be set as the Master. - Page 5 Once the memory has been cleared, the unit is ready to be configured. The LCD will display a warning that the unit has not been initialized. This display will rotate with the Longix Default display until a Total Update from Doors has been performed on the unit.
-
Page 6: Diagnostics And Troubleshooting
Longix LE-T1000 Telephone Entry Controller Installation Guide Diagnostics and Troubleshooting For information regarding the diagnostics screens and troubleshooting the Longix LE-T1000 Controller, see the Longix Troubleshooting and Diagnostics Guide. Contact Longix Technologies Inc. Longix Technologies Inc. 1063 King Street West, Suite 311, Hamilton, Ontario, L8S 4S3, Canada Telephone: 855.4LONGIX...