Prem-I-Air EH1372 Owner's Manual

2kw convector heater 2 heat settings adjustable thermostat free-standing or wall mounting convenient built-in carrying handle safety overload cut-out
Hide thumbs Also See for EH1372:

Advertisement

Quick Links

EH1372
2kW Convector Heater
2 Heat settings
Adjustable thermostat
Free-standing or wall mounting
Convenient built-in carrying handle
Safety overload cut-out
2 year guarantee
Page 1

Advertisement

Table of Contents
loading

Summary of Contents for Prem-I-Air EH1372

  • Page 1 EH1372 2kW Convector Heater 2 Heat settings Adjustable thermostat Free-standing or wall mounting Convenient built-in carrying handle Safety overload cut-out 2 year guarantee Page 1...
  • Page 2: Installation

    IMPORTANT Installer and Users please note: These instructions should be read carefully and left with the user of the product for future reference. INSTALLATION For free-standing use: attach the feet to the underneath of the heater using the four 12mm (½") screws. The feet fit over the second and third slots from the end of the case.
  • Page 3 DRILLING DIMENSIONS FOR WALL MOUNTING...
  • Page 4: Product Safety

    Children should be supervised to ensure that they do not play with the appliance • Place the EH1372 on a firm flat surface. Ensure that the air inlets (at the bottom) and the air outlets (at the top) are not obstructed.
  • Page 5: Operation

    OPERATION Plug the mains lead into a 13 Amp mains socket. If connecting via an extension lead, make sure that the lead is rated at 10 Amps or more, and that it is fully unwound. Switch the unit on at the mains socket. Use the two switches on the side to select the required operation: •...
  • Page 6: Maintenance

    £0.11 per unit (kilowatt-hour). The amount you are being charged will be shown on your electricity bill. At this cost, the EH1372 will cost £0.11 per hour to run on the "low heat " setting, and £0.22 per hour to run on the "high heat"...
  • Page 7: Fault Finding

    FAULT-FINDING The EH1372 has an overheat protection switch, which disconnects the power if the element gets too hot. The usual reason for this is because the air-flow has been obstructed, or the grilles have been blocked. If the heater ceases to operate, leave it for 20 minutes to cool down, then check that the grilles are not being obstructed.
  • Page 8: Service / Warranty

    SERVICE WARRANTY Prem-i-Air guarantees the product free from defects in materials and workmanship for a period of twelve months. This Elite product is guaranteed for a further twelve months subject to the enclosed registration card being completed and returned to the address printed on it, or the registration form being completed on-line at www.prem-i-air.com...

Table of Contents