Advertisement
HG2415G and HG2419G Installation Instructions
Determine the polarity which will be chosen
for the antenna installation. The antenna can
be installed either vertically or horizontally
polarized.
The two polarities are illustrated below:
Feed Reflector
Horizontal
Polarity
Important Note: Feed Reflector must be orientated to
grid as shown for optimal antenna performance.
Install the (2) Mast Clamps on the U-Bolts as shown
and fasten to the "L" Bracket using (4) lock washers
and (4) Nuts.
"L" Bracket
Mast Clamps
IP-00017 Rev. C – 05/05 Page 2 of 3
WWW.L-COM.COM E-MAIL: SALES@L-COM.COM PHONE: 1-800-343-1455 FAX: 1-978-689-9484
© L-com, Inc. All Rights Reserved. L-com Global Connectivity and the L-com logo are registered marks.
Position the "L" Bracket to the back of the Grid Assembly,
noting the orientation required for the desired polarity.
Position the Feedhorn to the front of the Grid Assembly,
again noting the orientation required for the desired polarity.
Secure the Feedhorn & "L" Bracket to the Grid Assembly
using (4) #M6 machine screws with lock washers, flat
washers and nuts.
Vertical
Feedhorn
Polarity
Mast
U-Bolts
L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845
Grid Assembly
OPTIONAL TILTED MOUNTING
Fixed Tilt Positions
To mount antenna assembly in a tilted position,
attach (1) U-Bolt assembly to either the fixed tilt
positions or to the tilt slot (as shown) on the
"L" Bracket.
Copyright © This drawing is property of L-com Global Connectivity. All rights reserved.
"L" Bracket
Tilt Slot
Advertisement
